Safestmonster MicroEars TE426 User manual

TE Amplified Phone Loop and Micro Headset Kit
Overview
Te426 offers wireless covert communication solution via phone.
Micro earpiece
TE26 has a built-in 3watt audio amplifier, so it can drive all kind of earpieces.
It includes Answer Button and Volume Control. 2 colors available,
beige and black.
Package includes:
1 x TE 26 Amplified Inductive Neckloop (Beige or black color)
1 x TE05,08, 07, 08P (earpiece box, 2 pcs batteries in the sponge)
1 x USB recharge cable
1 x USB AC charger
1 x Cleaning Brush
receives voice signals from inductive phone
neckloop TE26 wirelessly.
426
ON
OF F
Answer
Button
Volume
Control
Power Switch
Inductive
Neckloop
Phone Jack
Indicator
PAGE 1
Power Adaptor Charger Cable
Earpiece & batteries
1Wear Ear bud
A. Load battery into the earpiece
Open the plastic earpiece box and press the sponge, you will find
the battery. Cut the sponge and take it out.
Open the battery hook and make sure cathode face to handle and
anode opposite to handle. Then close the battery case.
*Note:
After loaded battery, earpiece starts work.
Do not load battery in wrong direction.
If the battery is loaded wrongly, the battery case will broken or
battery gets stuck inside the earpiece.
To be continued...
Quick Start
7
6
S
4
W
R
+
S
Handle
Battery Hook
7
6
S
4
W
R
+
Cathode Anode
S
Button Battery
Te08 Earpiece
7
6
S
4
W
R
S
+
Load Battery
7
6
S
4
W
R
+
S
Cleaning Brush
+
Te05 Earpiece

PAGE 2
To be continued...
TE 426
B. Load Earpiece
Clean ear canal by cotton swab.
Load earpiece into ear canal horizontally for maximize signal
reception. Handle is better in down position for easy take out.
Put earpiece into canal deeply until its invisible. Please take
out earpiece and unload battery when you finish using it.
Ear Canal
Eardrum
Load earpiece
Connect to mobile phone
Plug the jack into mobile phone audio port.
Swith on the neckloop once connected.
Default plug is 3.5mm 4pins. 2.5mm 4pins and Nokia flat jacks are also available.
1) 3.5mm 4pins jack fit to PC/laptop/ipod/ipad/mp3/mp4 players and most of the smart phones with iOS, Android, Bada systems.
Also works with some Nokia mobile phones.
2) 2.5mm 4pins jack fit to most of Nokia mobile phones.
3) Nokia flat jack is for Nokia phone only.
**
If the jack does not work on your mobile phone, please contact us as you may require a different connection.
Even the jack is the same, the audio and microphone connections might be different.
2
Audio Sources
Mobile phone, mp3, ipad, etc
ON
OF F
TE 26
Neckloop
Plug
into audio port
Wear the neckloop
You can wear the neckloop on neck as shown in the image
site down to drive sensitive earpieces including TE07/TE08P/TE09.
Power and volume control
Once connected to your mobile phone, move the Power Switch to the “ON” position. The indicator will change to a blue color
once power on.
In order to test the earpiece try playing some music on your mobile phone or mp3 player, you should now hear audio within your
spy earpiece (to use your earpiece see the earpiece manual). If you hear interference/noise its likely the volume is too high,
adjust the volume using the volume control.
When not using the neckloop for long periods of time, switch off the neckloop to save battery power.
Can also put neckloop in coat pocket or put on legs when you are
4
3
Volume
Controler
Turn on
Power Switch
Place neckloop
around the neck
ON
OFF
Amplified Phone Loop and Micro Headset Kit

PAGE 3
Start a covert conversation
Now make a phone call, you can talk with your partner via the
microphone build into the neckloop.
To answer a call simply tap the answer button.
** If earpiece detection equipment is in use, switch the unit off to
prevent detection.
5
To be continued...
ON
OFF
Tape
answer phone call
Microphone
TE 426
6Battery and recharge
The neckloop has a built-in 230mah lithium rechargeable battery. The full performance of a new battery is achieved only after
two or three complete charge and discharge cycles. The battery can be charge and discharge hundred of times, but its will
eventually wear out.
When recharge use only the supplied original default USB recharge cable and default wall charger. Do not leave a full charged
device on recharge power source. Overcharging may shorten battery life. If left unused, a full charged battery will loss its
charge over time.
We supply US/EU/UK standard plugs for the wall charger. Please choose correct plug while placing the order.
FAQ of TE26:
Q. Why microphone not working, or can not hear audio in the earpiece?
A. Firstly check your earpiece, do you hear a hissing noise when the battery is inserted. If so its likely the neckloop has a problem.
If the jack fits your phone but you can not hear any audio, or the microphone failes to work you may need a different jack.
Please contact us in this situation.
Q. Why answer button no works?
A. If the jack fits your phone but your cannot hear any audio, or the microphone failes to work you may need a different jack.
Please contact us in this situation.
Q. How to recharge battery?
A. Please read “Battery and Recharge” step #5 for detailed instructions.. Once connected to power charger successfully, the
indicator will change to red. You should find the indicator on the right side of the neckloop.
Q. Why I heard interference in the earpiece?
A. If earpiece has no quality problem, it is likely the volume is too loud. Use the volume control on the neckloop to adjust the
volume to get clear sounds.
Amplified Phone Loop and Micro Headset Kit

Warranty and return policy
Default warranty of TE26 is 12 months since ship date and Te05 Te08 TE07 is 6 months.
We do not accept return if product doesn’t has quality problem.
If it is within warranty and get broken, you can return it back and get free repair. Return shipping cost is on buyer’s behalf.
We will pay the shipping cost for sending repaired product.
If product is beyond the warranty, you need to pay returning shipping cost, repair fee and shipping cost for send repaired
product.
Warranty will be invalid in below conditions:
1) Passed 6 or 12 months since ship date.
2) Open case or and change circuits without our formal authorization.
3) Other kinds of problems caused by wrong operations.
Thank you for reading and Happy eCommerce!
PAGE 4
TE 426
Q. How to avoid earpiece detector with this neckloop?
A. Turn off the power switch to avoid earpiece detection equipment.
FAQ of Earpiece:
Q: There is no sound from the earpiece.
A: Please check if the battery is loaded correctly.
Q: Why I can hear little static noise?
A: It’s normal to hear some static noise. It means the earbud is under working
status.
Q: Why I hear loud “zzz” noise?
A: The battery is running of power. Please change to a new button battery.
Q: The Volume is low. What should I do?
A: Please check if wax filter is full. Please adjust the volume of cellphone and
neckloop.
Q: The battery life is very short.
A: Please use brand new high quality button battery. After using it, please take
the battery out of the battery commpartment.
Amplified Phone Loop and Micro Headset Kit