SAGITINE FLORENCE 8 BOX STAND User manual

1/1
FLORENCE 8 BOX STAND
ASSEMBLY INSTRUCTIONS
Parts:
Hardware:
Self-tapping screws
13mm long x12
Machine Screws
20 mm long x13
Screw-In Feet x4
ANo2PhillipsHeadScrewdriver
A No 4 Allen Key (Hex)
Vertical Frame
Side L x1
Vertical Frame
Side R x1
Vertical Frame
Mid x 1 Base Plate x2
Timber Top x1
To complete the assembly of your Florence Stand
you will need the following tools:
Within your delivery you’ll nd the following parts and hardware.
1
23 4
5
Rear Brace Short x2 Rear Brace Long x1
67
a
c
b

2/5
Place a clean towel or blanket on the ground rst to place the Timber Top on to
avoid scratching or marking the timber.
Place the Timber Top upside down on top of the towel or blanket on the ground
so that the holes are showing.
Step 1
x6
Place the Vertical Frame - Mid on top of the Timber Top making
sure the holes in the timber and the brackets are aligned.
Note: Ensure Threaded Insert
in the Frames is facing the rear.
Fasten the Frame to the
Timber Top with the 6x
Self Tapping screws.
Rear
Threaded Insert
a
1
1
2
2

3/5
Attach both Vertical Frames - Side L and R to the Timber Top as shown using 6x
Self Tapping screws.
Step 2
Note: Ensure all Frames are in line
with the rear edge of the Timber Top.
Fasten the Frame to the
Timber Top with the 6x
Self Tapping screws.
Rear
Threaded
Insert
Rear
Note: Ensure Threaded Insert
in the Frames is facing the rear.
3
4
x6
a

4/5
Place the Base Plates across the three Vertical Frames as shown, aligning the holes
with the Threaded Inserts.
Step 3
Fasten the Base Plates to the Vertical Frames
with 6x Machine Screws and 4x Screw-In Feet.
x6
x4
Larger hole
this side
52
4
3
5
c
b

5/5
Install the Rear Braces by aligning holes in the brace with the Threaded Inserts in
the Vertical Frames.
Step 4
Fasten with
7x Machine Screws.
Flip your Florence Stand so that the Timber Top is upright,
insert your 8 Milan Boxes and enjoy your new Sagitine piece.
Sagitine – Storage you want to see
www.sagitine.com
6
6
7
x7
b