Samsung LN40A650A1F Installation and operation manual

1
Samsung TV
F/W Upgrade Guide
Model : L650 Series
LN40A650A1F
LN46A650A1F
LN52A650A1F
Samsung Electronics

2
Step1. How to prepare the USB Memory Drive
2. Connect the USB Memory Drive
to the USB port of your PC.
Copy the file into the USB Memory Drive.
3. Go to the USB Memory Drive and then double click the file.
1. Save the firmware file into your computer.
File Name : T-AMBAUSC.exe
4. Just press “Unzip” button. 5. Unzipping is in progress.
6. After completing, please press
“OK” and “Close” button.
7. A folder containing the firmware files
has been added to the USB memory drive.
Folder Name : T-AMBAUSC
8. Safely disconnect the USB memory drive
by right clicking the green check mark
on the taskbar and then left click
“Safely Remove”.

3
Step2. How to upgrade the Firmware
with the latest Version
1. Turn your TV on, and then insert
the USB Memory Drive containing
the firmware upgrade into the
WISELINK port at the Side-AV panel.
2. Press the Menu button on your
Remote Control.
3. Go to Setup. On the Setup Menu,
select SW Upgrade, and then
press Enter or the arrow button
(▶) on your remote.
4. The TV scans the USB Memory
Drive.
※Important Notice
If firmware version you downloaded or received from the Samsung Web.
is older (smaller version) than the version on your TV, do not install it.
It can cause malfunction or disorder of your TV due to file system change.

4
Step2. How to upgrade the Firmware
with the latest Version
5. The TV asks whether you want to
upgrade. Select OK on the screen
, and then press the Enter button
on your remote.
6. The firmware upgrade starts.
7. After completing the firmware
upgrade, your TV turns off for
3 seconds and then turns back on.
8. Confirm that your TV has the new
firmware version,
Instructions to check the firmware
version is on the next page.
※Important Notice
If firmware version you downloaded or received from the Samsung Web.
is older (smaller version) than the version on your TV, do not install it.
It can cause malfunction or disorder of your TV due to file system change.

5
Step3. How to check the Firmware Version
1. Press the Menu button on
your remote control 2. Go to Setup. On the Setup Menu,
select SW Upgrade.
3. Press the Info button on your
remote. The firmware version
appears at the bottom of your
screen.
TV F/W Version : XXXX

6
Firmware Upgrade Error Messages
1. If the USB Memory Drive was not inserted into WISELINK port.
2. If there are no files on USB Memory Drive.
3. If the firmware version on the USB Memory Drive is same
as your TV’s firmware version

7
Cautions
While upgrading is in progress :
zDo not pull the USB Memory Drive out.
zDo not unplug the power cable.
zDo not turn the TV off.
※Warning
Pulling the USB Memory Drive out or unplugging the power
cable will cause a firmware error or main board failure.