Samsung TWMB-1900 User manual

Wallmount Setup guide
Guide de montage mural

English
Product Specications
Dimensions (W x H x D):
Weight (Kg)
Tilt angle
TWMB-1900
0.82 Kg
TWMB-2400
0.86 Kg
191 x 121 x 92 mm
Location of the holes to hold down
the wall mount in place 100 mm x 100 mm x φ4.5 (four)
-15° to 1°
The product design may differ depending on the model.
The specications of the product are subject to change without prior notice for
product enhancement purposes.
Components
Wall Mount Anchors and Screws Installation Instructions
Installation Precautions
1. The Wall mount is sold separately.
2. Check the strength of the wall prior to installation. If it is not strong enough, make
sure to reinforce the wall and only then install the product to it.
3. Make sure to connect the connection cable to the product before installing the wall
mount.
Safety Instructions
1. Do not let children play below product. They may hit their heads against corners.
2. Do not install the product in locations exposed to high temperatures or heavy
moisture, or to a wall that cannot hold the weight of the product.
3. Do not install a product other than the specied Samsung TV onto your wall mount.
Failing to do so, may result in the product falling and being damaged.
4. Do not hang onto the product.
5. Do not tilt the installed monitor so far upwards (15 degrees) that the top is closer
to you than the base. If the installed wall mount is loose, the product may fall and
cause personal injury.
Item

English
Installing
Caution: Make sure to install the wall mount onto a wall that is sufciently strong.
If you install the wall mount onto a wall made of gypsum board or wood, the product
may fall because the wall cannot support the product.
Remove the stand from the monitor. Mark the locations of the four (4) holes
of the wall mount on the wall.
Drill the marked locations to a depth
of 35 mm using a drill with a diameter
of 6.0mm.
⒜
4EA
4EA
⒝
Fix the anchors (a) into each hole on the
wall using a hammer. Fit the holes of the wall mount to those of the anchors and insert the screws
(b) into the tted holes.
A
Connect the cable before xing the
monitor onto the wall mount. Fix part A of the wall mount to the groove of the stand at the bottom of
the monitor.

BN68-01813A-X0