San Telequip SPS PSE 1310 Series User manual

San Telequip Private Limited.
504 & 505 Deron Heights, Baner Road
Pune 411045, India
Phone : [phone] Connecting. Converting. Leading !
email : [email protected] .
Page 1 of 2
Manual for POE injector SPS PSE 1310 Series
Product Introduction
POE injectors completely abides by IEEE802.3af protocols, 15.4 watts as port output
maximum power. This series includes 1000Mpbs speed rate POE products, supports
10/100 Mbps transmission rate.
Feature
Compliant with IEEE802.3, IEEE 802.3u, IEEE802.3 af standard
Offer10/100Mpbs RJ45port supporting POE function
2 x 10/100Mbps copper cable RJ45port + 1 AC female jack AC100-240Vinput.
Single POE port can support power up to15.4 watts (af)
Supply the power to devices that are compliant with IEEE802.3af standard
Suitable as desk mount and wall mount type
Up to level 2 lightning protection for network port and power input port
Technical Structure and Port Description
Indicator Status Description
Power Indicator : P
OFF : Power off
ON : Connected PD device, working properly
PoE indicator: PoE (Green LED)
Blink : Short circuit or Current overload
OFF : No connected PD device or No power supply
Note : Please make sure that powered devices conforms to IEEE802.3a

San Telequip Private Limited.
504 & 505 Deron Heights, Baner Road
Pune 411045, India
Phone : [phone] Connecting. Converting. Leading !
email : [email protected] .
Page 2 of 2
Connection Diagram Model description with details
s
Installation
Please confirm the following things before installation:
Whether POE port power supply power meet the power requirement of the connected
devices or not.
Whether the POE standard requirements and power supply mode match with the powered
device or not, Mid-span:4, 5+; 7,8- / End-span:1,2+;3,6-
Please install the POE injectors as per following steps:
Connect network devices with the Ethernet port via network cable
Connect with power cable and turn on the power.
After start up, the LEDs show following conditions:
Power LED indicator is on all the time
After the POE port connects with PD, POE indicator is ON.
Note
If the sequence is inconsistent with the above, please check the power.
Model Code : SPS PSE 1310 O AC
Single-port 10/100Mbps POE injector supports POE IEEE802.3af
AC100-240Vinput
POE port output power: 15.4watts
Total power: 18 watts.