Sanus Systems T20/20 User manual

Assembly Instructions for Sanus Systems T20/20
Thank you for choosing Sanus Systems furniture. Sanus Systems turntables are functional, beautiful, and economical. The
textured black painted fi nish is both durable and attractive. The T20/20 is designed to swivel up to a 20” television. Please
check carefully to make sure there are no missing or defective parts. Never use defective parts. Improper assembly may
cause damage or serious injury. If you have any questions regarding this product, contact Sanus at 800.359.5520 or visit
www.sanus.com. Our customer service representatives can quickly assist you with missing or damaged parts. Replacement
parts for Sanus products purchased through authorized dealers can be shipped directly to you. Please call Sanus Systems
before returning products to the point of purchase.
Required Tools: Philips screw driver, hammer
Supplied Parts:
(1) Base Shelf - a (2) Support Pillar - b
(4) Plastic Dowel - c (4) Base Bolt - d
(1) Top Shelf - e
Sanus Systems
2221 Hwy 36 West, Saint Paul, MN 55113 6.06.04
Customer Service: 800.359.5520. See complimentary Sanus products at www.sanus.com
Diagram 1
Philips Head Screw
To use the T20/20 as just a television swivel, follow the
instructions in the note below. To use the complete as-
sembly, skip ahead to Step 1.
NOTE:
For use without the component storage remove
the plastic swivel from under the Base Shelf (a). This is
done by removing the Philips head screw in the center.
Next, reattach the plastic swivel to the pilot hole on the
bottom side of the Top Shelf (e).
a

Sanus Systems
2221 Hwy 36 West, Saint Paul, MN 55113 6.06.04
Customer Service: 800.359.5520. See complimentary Sanus products at www.sanus.com
Diagram 2
c
b
Diagram 3
d
a
Diagram 4
c
b
e
Step 1:
The Support Pillars (b) each have two smaller
holes in the top and two larger holes in the bottom. Gently
tap 2 Plastic Dowels (c) into the larger holes in each of the
Support Pillars with a hammer as shown in Diagram 2.
Step 2:
Notice that the two holes in the other side of the
Support Pillars (b) line up with the holes that pass through
the Base Shelf (a). Attach the Support pillars to the Base
Shelf by placing a Base Bolt (d) through each hole in the
Base Shelf and threading them into the open holes in the
Support Pillars. Tighten the Base Bolts with a philips
screw driver as shown in Diagram 3.
Step 3:
The Top Shelf (e) will have 4 holes that do not
pass all the way through the shelf. Make sure the Top
Shelf and the Base Shelf (a) are oriented the same way,
both of the angled sides should face the same direction.
Next, line up the holes in the Top Shelf with the Plastic
Dowels (c). Finally, press the Top Shelf and the Support
Pillars (b) together as shown in Diagram 4.
Step 4:
Turn the unit over so that it sits on the Protective
Feet attached to the bottom of the plastic swivel. You may
now place your television on top of the turntable, a com-
ponent in your storage area, and enjoy the convenience of
a perfect viewing angle anywhere in the room.