Sanus Systems VMCT User manual

Assembly Instructions for Model: VMCT
Thank you for choosing a Sanus Systems VMCT. This product is designed to work with other products to easily and safetly
contain and hide component cables, power cords, and wires.
If you do not understand these directions, or have any doubts about the safety of the installation, please call a qualied
contractor or contact Sanus at 800.359.5520 or www.sanus.com. Our customer service representatives can quickly assist
you with installation questions and missing or damaged parts. Replacement parts for products purchased through authorized
dealers will be shipped directly to you. Check carefully to make sure that there are no missing or defective parts. Sanus
Systems can not be liable for damage or injury caused by incorrect mounting, incorrect assembly, or incorrect use. Please
call Sanus Systems before returning products to the point of purchase.
NOTE:
The supplied wall mounting hardware is not for metal stud, concrete, brick, or block walls. If you are uncertain
about the nature of your wall, consult an installation contractor. Sanus makes every effort to assure all necessary
mounting hardware is included. If the hardware you need is not included please consult your local hardware
store or call Sanus Systems.
Required Tools: Drill, 3/16” drill bit, 3/8” drill bit, and a philips screw driver
Supplied Parts and Hardware: (Threaded fasteners are shown actual size.)
Sanus Systems 2221 Hwy 36 West, Saint Paul, MN 55113 07.12.06 (6901-100078)
Customer Service: 800.359.5520. See complementary Sanus products at www.sanus.com
Wall Plate - A
Qty. 2
Cover - B
Qty. 2
Wood Screw - C
Qty. 4
Anchor - D
Qty. 4

CSAV, Inc. and its afliated corporations and subsidiaries (collectively, “CSAV”), intend to make this manual accurate and complete. However, CSAV makes no claim that the information contained herein
covers all details, conditions, or variations. Nor does it provide for every possible contingency in connection with the installation or use of this product. The information contained in this document is subject to
change without notice or obligation of any kind. CSAV makes no representation of warranty, expressed or implied, regarding the information contained herein. CSAV assumes no responsibility for accuracy,
completeness or sufciency of the information contained in this document.
Step 1: Attach Wall Plate
NOTE:
Do not overtighten the Wood Screws (C). Tighten the Wood Screws only until the Wall Plate (A) is pulled rmly
against the wall. If there is a layer of drywall or other material, this drywall or other material may not exceed 5/8
inch [15.8 mm] in thickness.
Orient the Wall Plate (A) so that its at side is against the wall as shown in Diagrams 1A and 1B and use the Wall plate as
a template to mark the two holes for the Wood Screws (C) on the chosen stud. Drill two pilot holes using the 3/16 inch drill
bit; then, using the Wood Screws, secure the Wall Plate to the stud as shown in Diagram 1A.
If the VMCT is to be mounted between studs, drill two holes in the drywall or wall material using the 3/8 inch drill bit; then,
insert the Anchors (D) and secure the Wall Plate as shown in Diagram 1B
Diagram 1A Diagram 1B
A A
CC
D
Step 2: Wire Management and Cover Installation
NOTE:
Make sure all wires and cables are between the right and left edge of the Wall Plate (A) prior to installing the
Cover (B).
Press t the Cover (B) onto the Wall Plate (A) so each Tab on the Cover ts into each Slot in the Wall Plate as shown in
Diagram 2.
Diagram 2
A
B
Tab
Slot