Sanus SA405 User manual

SA405
INSTRUCTION MANUAL
If you have any questions along the way, just give us a call:
1-800-359-5520 we’re ready to help!
We’ll Make It Stress-Free

2
WARNING:
 This soundbar mount is only designed to be used with TV wall mounts that meet third
party safety certifications.
 This soundbar mount is only designed to mount sound bars BELOW the television (see
Figure 1).
Please check the following items:
Your TV and any accessories you plan to use do not exceed the specified weight limit of
your TV wall mount.
You read and understand these directions.
You refer to the documentation that came with your sound bar and TV wall mount for
additional guidance.
You have the tools needed for installation.
If you have any questions, please contact Customer Service: 1-800-359-5520 .
IMPORTANT SAFETY INSTRUCTIONS – SAVE THESE INSTRUCTIONS – PLEASE READ ENTIRE MANUAL PRIOR TO USE
Before You Begin

3
 If the TV wall mount does not include TV interface
spacers; do not use the TV interface spacers included
with this soundbar mount.
 If the TV wall mount has built-in or integrated spacers
(see Figure 2); do not use this product.
 This soundbar mount should only be installed into TV
interface bracket slots or holes that are less than 11 mm
(.43 in.) wide; do not over-tighten washer (see Figure 3).
 This soundbar mount was designed to be installed
and utilized only as specified in this manual. The
manufacturer is not responsible for improper assembly,
use, or handling of this product.
 The wall must be capable of supporting five times the
weight of the TV, mount, and soundbar combined.
 Failure to follow these instructions could result in an
unstable situation that may result in property damage or
personal injury.
Figure 1
TV
Soundbar
Figure 2
Figure 3

4
3RD PARTY CERTIFIED TV WALL MOUNT*
*Your TV wall mount may vary from the TV wall
mount shown throughout this manual. That is OK. The
installation procedure will be the same.
Weight Limit for the SA405 Items Needed
15 lb (6.8 kg)
DO NOT EXCEED!
Phillips Screwdriver
Level
CAUTION: Avoid potential personal injuries
and property damage!
You must verify that the weight of the TV plus the
soundbar mount, soundbar, and any accessories
is lower than the maximum weight rating of the
TV mount.

5
05 05
05
NOTE: Before you
begin assembling this
soundbar mount, please
note that theTV/bracket
arms 05 should be
positioned as vertically
as possible.
Arm Position

6
NOTE: Not all hardware included will be used.
Supplied Parts and Hardware
WARNING: This product contains small items that could be a choking hazard if swallowed.
Before starting assembly, verify all parts are included and undamaged. If any parts are missing or damaged,
do not return the damaged item to your dealer; contact Customer Service. Never use damaged parts!
Parts and Hardware for STEP 1 (and 3)
01 x 2 x 2
02
x 2
03
x 4
04
Soundbar Bracket Arm “C” Washer
Keyhole Screw
Knob

7
05 x 2
x 2
06
TV Bracket Arm
Parts and Hardware for STEP 3 Hardware for TV Bracket
M4/M5
07 x 4
Large M4/M5
09 x 4
M6/M8
08 x 4
Large M6/M8
10 x 4
TV Screw Washers
Soundbar
Mount Spacer

8
Hardware for TV Bracket
M8 x 20mm
15 x 4
M6 x 25mm
14 x 4
M6 x 16mm
13 x 4
M5 x 16mm
12 x 4
M4 x 16mm
11 x 4
Screws for TVs with a Flat/Unobstructed Back

9
Hardware for TV Bracket
M8 x 40mm
20 x 4
M6 x 50mm
19 x 4
M6 x 40mm
18 x 4
M5 x 40mm
17 x 4
M4 x 40mm
16 x 4
Screws for TVs with Irregular/Obstructed Backs
21 x 4
Spacer for TVs
with Irregular/
Obstructed Backs

10
Check the compatibility of the soundbar bracket with your soundbar.
Assemble knobs 04 and screws 03 .
Attach the soundbar arms 01 to soundbar. Do not fully tighten the knobs 04 .
04
03
NOTE: When planning on the position of
the soundbar, make sure you will be able
to access the control buttons.
Mount Bracket Arms to Soundbar - Option 1
STEP 1

11
01
01
04
03

12
Mount Bracket Arms to Soundbar - Option 2
STEP 1
Check the compatibility of the soundbar bracket with your soundbar.
Assemble knobs 04 and screws 03 .
Some connections to the soundbar may require a “C” washer 02 to ensure that the
soundbar arms 01 lay flat on the soundbar. If required, slip a “C” washer 02 onto the
knob screws 03 and under the arms 01 and loosely tighten the knobs 04 .
04
03
NOTE: When planning on the position of
the soundbar, make sure you will be able
to access the control buttons.

13
01
01
04
04
02
02
02 03
04

14
Some soundbars will come with a manufacturer supplied hanger.
Attach the soundbar arms 01 to the soundbar hanger with knobs 04 and screws 03 .
Do not fully tighten the knobs 04 .
Mount Bracket Arms to Hanger - Option 3
STEP 1
NOTE: When planning on the position of
the soundbar, make sure you will be able
to access the control buttons.

15
01 01
04
03
SOUNDBAR
MANUFACTURER
SUPPLIED HANGER

16
STEP 2 Prepare TV
A
If yourTV is already mounted:
A. Remove any cables attached to theTV.
B. Remove theTV/bracket assembly from the wall
plate, arm assembly, or pillar. Please see your
TV wall mount installation manual for guidance.
HEAVY! You may need assistance with this step!
C. Remove theTV bracket from theTV.
IMPORTANT!
!Please see yourTV wall mount manual
for instructions on how to remove theTV
interface bracket.
!Save theTV hardware in case you want to use
theTV without the soundbar in the future.
!You must use the hardware provided with
this product instead of the hardware that
came with your mount.

17
B
C

18
STEP 3
Install TV Bracket with the TV/Bracket Arms
Determine the bolt diameter for your monitor
and your TV type - M4, M5, M6, or M8.
D 47!#8<.9-&Cat/unobstructed back, see
Step 3-1
D 47!#8<.9-&3.77*,:1&74'897:(9*)'&(0
see Step 3-2
If you need extra space to accommodate cables,
recesses, or protrusions, see Step 3-2 that uses spacers.
Standard confi,:7&9.438&7*8-4<34785*(.&1
applications, contact Customer Service.
CAUTION: Verify adequate thread engagment
with the screw or screw/spacer combination.
- Too short will not hold the TV.
- Too long will damage the TV.
Step 3-1 Step 3-2

19
STEP 3-1
NOTE: Soundbar must be mounted
below theTV as shown.
WARNING: You
must use the larger
washers 09 or 10
unless they do not fit
yourTV bracket.
NOTE: Install
screws but
do not fully
tighten before
Step 6.
11 12 13 14 15
07 08 09 10
06
06
05

20
STEP 3-2
16 17 18 19 20
21
06
06
05
07 08 09 10
NOTE: Soundbar must be mounted
below theTV as shown.
WARNING: You
must use the larger
washers 09 or 10
unless they do not fit
yourTV bracket.
NOTE: Install
screws but do
not tighten
before Step 6.