PRECAUTIONS
In cas of malfunction
Do not use the camera if smoke or a strange odour comes from the
unit, or if it seems not to function correctly. Disconnect the power
supply immediately, and consult your dealer (or a Sanyo Authorized
Service Center).
Do not op n or modify
Do not open the cabinet, as it may be dangerous and cause damage
to the unit. For internal settings and repairs, consult your dealer (or a
Sanyo Authorized Service Center).
Do not put obj cts insid th unit
Make sure that no metal objects or flammable substances get inside
the camera. If used with a foreign object inside, it could cause a fire,
short-circuit or damage.
If water or a liquid gets inside the camera, disconnect the power
supply immediately, and consult your dealer (or a Sanyo Authorized
Service Center). Be careful to protect the camera from sea water, etc.
B car ful wh n handling th unit
To prevent damage, do not drop the camera or subject it to strong
shock or vibration.
Install away from l ctric or magn tic fi lds
If installed close to a TV, radio transmitter, magnet, electric motor,
transformer, or audio speakers the magnetic field they generate will
distort the image.
Prot ct from humidity
To prevent damage to the camera, do not install it where there is
greasy smoke or steam or where the dampness may get too high.
Prot ct from high t mp ratur s
Do not install close to stoves, or other heat generating devices, such
as spotlights, etc., or where it could be subject to direct sunlight, as
that could cause deformation, discoloration or other damage.
Be careful when installing close to the ceiling, in a kitchen or boiler
room, as the temperature may rise to high levels.
Install where the temperature range will stay between –10°C and
50°C. (no condensation)
Cl aning
Dirt can be removed from the housing by wiping it with a soft cloth.
To remove stains, wipe with a soft cloth moistened with a soft
detergent solution and wrung dry, then wipe dry with a dry soft cloth.
Do not use benzine, thinners or other chemical products on the
housing, as they may cause deformation and paint peeling. Before
using a chemical cloth, make sure to read all accompanying
instructions. Make sure that no plastic or rubber material comes into
contact with the housing for a long period of time, as that may cause
damage or paint peeling.
Mounting Surfac
The mounting surface material must be strong enough to secure the
camera. Plaster- board without a backing plate is not recommended.
L5AK4/US, L5AL4/US GB 2003, 4, 17
English 3
