Sapido HG-3105 User manual

5/8 Port GIGABIT Switch *1
Power Adapter*1
Quick Installation Guide*1
Power LED:LED is on means the switch is power on.
Ethernet Speed/ Link/Act LED:
1.The solid LED means well connection, and the flash
LED represents data transmitting.
2.The meanings of LED color
-Orange On:1000Mbps Gigabit connected
-Orange Flash: 1000Mbps Gigabit connection activity
-Green On:10/100Mbps connected
-Green Flash:10/100Mbps connection activity
Front Panel of HG-3108-
Device Introduction/ 部品介紹:
LED Indicators / LED 狀態指示燈
【The Front Panel/正面面板】
Front Panel of HG-3105-
5/8 Por t G I G A B I T S w i tc h
HG-3105/HG-3108
Quick Installation Guide (V1.1)
Package Content / 包裝內容物:
Ethernet Speed/ Link/Act Power/電源
5/8 埠超高速GIGABIT乙太網路交換器
簡易安裝操作指南
5/8埠超高速GIGABIT乙太網路交換器*1
變壓器 *1
簡易安裝操作指南 *1
電源指示燈 - 亮起表電源正常。
乙太網路速度/連線/傳輸指示燈
1.恆亮時表示連線正常，閃爍時表示該連接埠正在傳輸資料。
2.指示燈的顏色狀態
-橘色燈號恆亮: 以1000Mbps連線中
-橘色燈號閃爍: 以1000Mbps傳輸中
-綠色燈號恆亮: 以10/100Mbps連線中
-綠色燈號閃爍: 以10/100Mbps傳輸中
HG-3105 正面 HG-3108 正面
886-6-2280698 886-6-2293658
[e-mail]
383, Sec. 2, Minsheng Rd.,West Central District,
Tainan City700,Taiwan
SAPIDO Technology Inc.
www.sapido.com.tw

Installation / 安裝 :
Step3 / 步驟三:
Connect the power adapter into the back of the switch, and then power on the unit. After that,
the Power LED will be on, and the Ethernet Speed/ Link/Act LEDs which correspond to the
Ethernet ports linked with PC or device will also be on.
將變壓器連接交換器背面的電源插孔，再插入電源插座。
此時交換器電源燈會亮起，交換器上有連接電腦或網路設備的網路連接埠的對應燈號也會亮起。
Q&A / 常見問題:
Q:The Power LED is off.
A :The Switch is power off.
Please check whether the power adapter is properly plugged in the socket.
If it is well plugged, make sure the socket is on.
Q:Ethernet Speed/ Link/Act LED is not lit for a connected device.
A :Please make sure the cable connectors are securely plugged in at the switch and the device.
Also, check the connected device is turned on and installed correctly.
問: 電源燈未亮
答: 電源燈未亮則無電源，請確認變壓器是否正確接再電源插座上。
若已接上插座，確定電源插座是在開啟狀態。
檢查變壓器是否已連接至交換器電源插孔，並確認沒有鬆脫。
問：網路接線連接埠的燈沒有亮
答：請確定連接交換器的電腦或是網路設備已開啟。
確定網路線有正確連接在交換器和電腦或是網路設備上。
5V DC
Power Jack / 電源孔
Step 2 / 步驟二:
Use Ethernet Cable to connect any Ethernet port on the switch with PC.
將網路線一端連接到交換器背後的連接埠，再將另一端連接到電腦。
【The Rear Panel / 背面面板】
Rear of HG-3105/ HG-3105 背面 Rear of HG-3108 / HG-3108背面
10/100/1000 Mbps Ethernet Ports
Step 1 / 步驟一:
Use Ethernet Cable to connect any Ethernet port on the switch with network devices (modem or router).
將網路線一端連接到交換器背後的連接埠，再將另一端連接到網路設備(數據機或是路由器)。
10/100/1000 Mbps 乙太網路連接埠