Sapir SP-7100-GE User manual

_English_
Electric Faucet
SP-7100-GE / HE
INSTRUCTION MANUAL
Please read this user manual prior to use of the electric faucet, thereafter save it for future reference.
Features and Function:
1. Plastic structure.
2. Water and electricity double-insulated.
3. Professional scale-proof design
4. Thermal fuse for safety
5. Easy installation
Cautions:
1.Make sure to follow the installation instructions.
2.Make sure water is connected before you plug the unit in for the first time.
3.Nozzle needs to be cleaned regularly (about once per month).
4.If the water has been frozen in the faucet, the heating is prohibited.
5.If the supply cord is damaged in any way, it must be replaced by the manufacturer or its
service agent or a similarly qualified person in order to avoid a hazard.
6.This product is intended for use indoors and must be earthed.
7.After using hot water, cool the faucet down by running cold water for five seconds, this will
ensure that the unit does not get damaged.
8.Appliance is not to be used by children or persons with reduced physical, sensory or mental
capabilities, or lack of experience and knowledge, unless they have been given supervision
or instruction
9.Children being supervised not to play with appliance.
10. Тhe outlet must not be connected to any tap or fitting other than those specified.
11. Appliance is not to be installed in locations where freezing can occur.
12. In electronic circuit designed to mount a water heater must be installed such a device in
terms of overvoltage Category III provides a complete disconnection of all poles.

_English_
Installation instructions:
1. Please fix the faucet and connect the water pipe correctly; turn the handle and let the water
out, and check if there is any water leakage.
2. Connect the power supply.
3. Heating indicator light will be on when turning to hot water level and begin to heat up, while
turning to cold water level the light will be off and stop heating.
Usage:
1. How to use the handle switch
As shown below, the rotation range is 0-150 degrees. Each of hot water area and cold water
area is 60 degrees, while the remaining 30 degrees is no water area.
Nozzle
Handle switch
Faucet body
Basin
Power cord
Water pipe
Connecting nut
Connecting screw
FIGURE A
Nozzle
Handle switch
Faucet body
Basin
Power cord
Water pipe
Connecting nut
Connecting screw
FIGURE B

_English_
2. The usage of indicator light
If heating indicator light is ON that indicates heating at the moment.
3. Regular cleaning of nozzle
Open the nozzle and put it upside down under the high pressure faucet until it is clean
enough.
Failure analysis and Troubleshooting:
Trouble Possible reason Shooting way
Water is not hot The power plug is detached, disconnected power or the
water pressure is too low.
Check the power supply, the water
pressure and keep the water
pressure not lower than 0.04MPa.
Water with low
temperature The water pressure is too high, or the power supply is too low. Adjust unit to allow the water to run out slowly.
Water with high
temperature The water pressure is too low, or inlet or outlet blockage. Check the water pressure, clean the inlet and outlet.
Hot water
Hot water
Cold water
Cold water
No water
No water
Dismantle nozzle
High-pressure
water washing

_English_
Indicator light does not
work. The water pressure is too low or circuit fault. Please contact local service agent.
Technical specification:
Model: SP-7100-GE / HE
Voltage range: 220-240V, ~50Hz,
Rated power input: 3000W
Protection against electric shock: Class I
IP code: IP24