3
2
1
10
9
8
7
6
4
12
11
5
Front Rear Side
Button Functionality
The callouts in the previous figure are described in the table below from left to right.
Main Control Buttons and OLED Screen
Main Control Buttons and OLED Screen
Main Control Buttons and OLED Screen
Press to return to home screen
Press and hold home and power for four seconds
Displays service and zone information
These buttons navigate the OLED screen
Press to go back, up or down on OLED
Press to return to previous chapter
Press to go to next chapter
Press to resume last live TV channel
Set top box selection buttons
Set top box selection buttons
Set top box selection buttons
Cable TV provider selection button
Cable TV provider selection button
Cable TV provider selection button
Cable TV provider selection button
Volume, Channel and Navigation buttons
Volume, Channel and Navigation buttons
Volume, Channel and Navigation buttons
Up, Down, Left, Right Navigation
Press to navigate up, down, left or right
Press to confirm selection
Press for channel up/down
Mute, Savant and Last button
Mute, Savant and Last button
Mute, Savant and Last button
Press to launch Savant OSD
Press to return to last channel
Press to enter decimal points
Press to confirm selection
Regulatory
The following statements are applicable to the SUR-0500.
Note: This equipment has been tested and found to comply with the limits for CLASS B digital
device, pursuant to Part 15 of FCC Rules. These limits are designed to provide reasonable
protection against harmful interference when the equipment is operated in a residential
environment. This equipment generates, uses and can radiate radio frequency energy and, if not
installed and used in accordance with the instructions, may cause harmful interference to radio
communications, However there is no guarantee that interference will not occur in a particular
installation, If this equipment does cause harmful interference to radio or television reception,
which can be determined by turning the equipment off and on, the user is encouraged to try
correct the interference by one or more of the following measures: 1.1. Reorient or relocate the
receiving circuit different from that to which receiver is connected. 1.4. Consult the dealer or
experienced radio/TV technician for help. The changes or modifications not expressly approved by
the party responsible for compliance could void the user's authority to operate the equipment.
This device complies with part 15 of the FCC Rules. Operation is subject to the following two
conditions: (1) This device may not cause harmful interference, and (2) this device must accept
any interference received, including interferences that may cause undesired operation.
"CAUTION" : Exposure to Radio Frequency Radiation. Antenna shall be mounted in such a
manner to minimize the potential for human contact during normal operation. The antenna should
not be contacted during operation to avoid the possibility of exceeding the FCC radio frequency
exposure limit.
“CAUTION” : Risk of explosion if battery is replaced by an incorrect type. Dispose of used
batteries according to the instructions.
This device complies with Industry Canada license-exempt RSS standard(s). Operation is subject
to the following two conditions: (1) this device may not cause interference, and (2) this device
must accept any interference, including interference that may cause undesired operation of the
device.
Le présent appareil est conforme aux CNR d'Industrie Canada applicables aux appareils radio
exempts de licence. L'exploitation est autorisée aux deux conditions suivantes: (1) l'appareil ne
doit pas produire de brouillage, et (2) l'utilisateur de l'appareil doit accepter tout brouillage
radioélectrique subi, même si le brouillage est susceptible d'en compromettre le fonctionnement.
Additional Documentation
Additional information is available at: dealers.SavantSystems.com:
Dealer Login > Knowledge Base > Savant Hardware > Remotes
Savant Universal Remote
(SUR-0500)
Quick Reference Guide
110613
