Initial Setup
1. Press & Hold the power button for 6 seconds until a splash screen appears.
2. Once the splash animation stops, press the button to the left or right of the
network name to select it.
3. If the network is protected, enter the network password, and press the button
under Next.
4. After the remote connects to the network, press the button to the left or right of
the Savant® host to connect to.
5. Press the button to the left or right of the room to control.
IMPORTANT! Before using the SUR-0500 for the first time, update the firmware to the
latest version. Perform the steps outlined in Updating Firmware immediately after
Initial Setup.
Updating Firmware
1. Press the Back button until the root screen appears.
2. Press the button to the left or right of Settings on the screen.
3. Press the button to the left or right of Updates on the screen.
4. Press Update to download and install the update.
IMPORTANT! The remote will reboot after the update is installed, and will be inactive for
several minutes before the start screen animation appears.
There are 3 updates that may be available, repeat steps 1 to 4 until until the dialog screen
No updates have been found at this time. Then press back to exit.
Additional Documentation
Additional documentation for the SUR-0500 is available at www.SavantSystems.com.
•Deployment Guide for configuring the SUR-0500 for use within a Savant system.
•Application Notes for additional information on configuring, and using the SUR-0500.
Regulatory
The following statements are applicable to the SUR-0500.
Note: This equipment has been tested and found to comply with the limits for CLASS B
digital device, pursuant to Part 15 of FCC Rules. These limits are designed to provide
reasonable protection against harmful interference when the equipment is operated in a
residential environment. This equipment generates, uses and can radiate radio frequency
energy and, if not installed and used in accordance with the instructions, may cause
harmful interference to radio communications, However there is no guarantee that
interference will not occur in a particular installation, If this equipment does cause harmful
interference to radio or television reception, which can be determined by turning the
equipment off and on, the user is encouraged to try correct the interference by one or
more of the following measures: 1.1. Reorient or relocate the receiving circuit different
from that to which receiver is connected. 1.4. Consult the dealer or experienced radio/TV
technician for help. The changes or modifications not expressly approved by the party
responsible for compliance could void the user's authority to operate the equipment.
This device complies with part 15 of the FCC Rules. Operation is subject to the following
two conditions: (1) This device may not cause harmful interference, and (2) this device
must accept any interference received, including interferences that may cause undesired
operation.
CAUTION: Exposure to Radio Frequency Radiation. Antenna shall be mounted in such a
manner to minimize the potential for human contact during normal operation. The
antenna should not be contacted during operation to avoid the possibility of exceeding
the FCC radio frequency exposure limit.
CAUTION: Risk of explosion if battery is replaced by an incorrect type. Dispose of used
batteries according to the instructions.
This device complies with Industry Canada license-exempt RSS standard(s). Operation is
subject to the following two conditions: (1) this device may not cause interference, and (2)
this device must accept any interference, including interference that may cause
undesired operation of the device.
Le présent appareil est conforme aux CNR d'Industrie Canada applicables aux appareils
radio exempts de licence. L'exploitation est autorisée aux deux conditions suivantes: (1)
l'appareil ne doit pas produire de brouillage, et (2) l'utilisateur de l'appareil doit accepter
tout brouillage radioélectrique subi, même si le brouillage est susceptible d'en
compromettre le fonctionnement.
Copyright © 2014 Savant Systems, LLC. SAVANT and RacePoint Blueprint are trademarks of Savant Systems, LLC.
All brand names, product names and trademarks are the property of their respective owners.
Savant Systems, LLC reserves the right to change product specifications without notice.
Savant Universal Remote
(SUR-0500)
Quick Reference Guide
Savant Confidential and Proprietary
