Savortex eCurve 550A User manual

A Smart Energy Saving Revolution
EcoCurveTM Hand Dryer
eCurve 550A and eCurve 550D
Speci cation
Surface mounted Low Energy – High Speed hand dryer. Model numbers: eCurve 550D with data reporting function and
eCurve 550A without data reporting function, of PC/ABS anti-bacterial case, stainless steel back plate. 550W, 230V.
Manufactured by SAVORTEX Ltd, UK.
Material
Case: PC/ABS with antibacterial additive
Back plate: Stainless Steel
Operation
To activate dryer place hands under the dryer. Dryer has a built-in automatic cut out of 30 seconds.
SAVORTEX Ltd reserves the right to amend the design or dimensions without formal notice. © SAVORTEX Ltd 2014
SAVORTEX Ltd: 1 Canada Square, Canary Wharf, London, E14 5DY | T: [phone] | F: [phone] | E: inf[email protected]

A Smart Energy Saving Revolution
Installation
Mains Voltage: 230 – 240 V AC, single phase 50Hz
Motor Power Consumption: 550W (+/- 10%)
Power Standby: Below 1W
Amps: 3 amps
Motor: Digital Brushless Motor DC, Anti-particulate, Ozone emissive, Energy e cient 20,000 rpm
EMC: Complies with Electromagnetic Compatibility
GSM Connection (Models with “D” su x part numbers): Automatic GSM con guration.
Securely x the mounting bracket to the wall at the desired location. Hand dryer should be mounted vertically on solid
substrate walls.
Isolate the mains before commencing installation.
An isolation switch is required external to the dryer.
Correctly wire the power cable to the electrical connector via the rear entry through the access grommet, in accordance
with the current edition of the IEE wiring regulations (BS7671: Requirements for Electrical Installations).
Replace all electrical connector covers and insulation. Our dryers use rst x principles to minimize installation times.
When required, align the main unit over the mounting bracket ensuring the top two hooks are secure.
Align with the corresponding openings in the rear. The main unit should be held ush with the wall.
Lower the unit slowly down to engage with the hooks and with the electrical connector until the lower face is ush with
the bottom edge of the bracket.
Fix the unit to the bracket with the two anti-tamper screws.
Reconnect the power.
The unit will self-isolate upon removal of the main unit from the mounting bracket.
Recommended mounting height from underside of unit:
Male washroom: FFL to underside of dryer – 1080mm
Female Washroom: FFL to underside of dryer –980mm
Universal Access Washroom: FFL to underside of dryer – 850mm
Children: FFL to underside of dryer – 850mm
Care and Maintenance
Clean with soap and warm water, dry with a clean soft cloth. Abrasive cleaners, chloride and citrus based cleaning agents
should not be used.
Warranty
This product is covered by a 7 years warranty of 12 months parts and labour and an additional 6 years parts warranty from
the date of purchase to be free from defects if installed and maintained in accordance with these instructions. SAVORTEX Ltd
will replace or repair (as appropriate) free of charge any product with a proven manufacturing defect if reported within the
warranty period. Please see SAVORTEX Ltd Standard Terms of Sale for details. Copies available on request from
[e-mail].
SAVORTEX Ltd reserves the right to amend the design or dimensions without formal notice. © SAVORTEX Ltd 2014
SAVORTEX Ltd: 1 Canada Square, Canary Wharf, London, E14 5DY | T: [phone] | F: [phone] | E: inf[email protected]