SB SB9126 User manual

User manual
Handheld Blender
SB9126 GB
Carefully read these instructions and keep this manual for future reference.

2
Important safety instructions
Before using the SB9126 electrical appliance, the following asic precautions should
always e followed including the following:
1. Read all instructions.
2. Before using check that the voltage of wall outlet correspond to the one shown on the
rating plate.
3. Do not operate any appliance with a damaged cord or plug or after the appliance
malfunctions, or is dropped or damaged in any manner. Return appliance to the
nearest authori ed service facility for examination, repair or electrical or mechanical
adjustment.
4. If the supply cord is damaged it must be replaced by the manufacturer or a
authori ed service agent or a qualified technician in order to avoid a ha ard.
5. Unplug from outlet when not in use, before putting on or taking off parts, and before
cleaning.
6. Do not let cord hang over edge of table or hot surface.
7. Do not immerse upper part of blender into water as this would give rise to electric
shock.
8. Close supervision is necessary when your appliance is being used near children or
infirm persons.
9. Avoid contacting moving parts.
10. Keep hands and utensils out of container while blending to reduce the risk of severe
injury to persons or damage to the blender. A scraper may be used but must be used

3
only when the blender is not running.
11. The appliance cannot be used for chopping ice or blending hard and dry substance,
otherwise the blade could be blunted.
12. The use of accessory not recommended by the manufacturer may cause injuries to
persons.
13. Do not operate the appliance for other than its intended use.
14. This appliance is not intended for use by persons (including children) with reduced
physical, sensory or mental capabilities, or lack of experience and knowledge, unless
they have been given supervision or instruction concerning use of the appliances by a
person responsible for their safety.
15. Children should be supervised to ensure that they do not play with the appliance.
16. Do not use outdoors.
17. Save these instructions.

4
Before the first use
SB9126
8718226350206
Clean the blender according to the section of “quick cleaning”.
The time running unit without load can’t exceed 15s.
Important
Blades are very sharp, handle with care. Ensure that the hand-held blender is unplugged from
the power outlet before assembling or removing attachments.

5
Using the lender
Max operation duration under high speed per time cannot exceed 1 minute.
1. To assemble the detachable shaft with the motor unit, turn the shaft anti-clockwise
direction until tightened. To disassemble, just turn in the adverse direction.
2. Simply plug the hand-held blender to power outlet.
3. Lower the hand-held blender into food and depress the switch at the top of the motor
unit.
4. To stop the hand-held blender release the switch at the top of the motor unit.

6
Cleaning and maintenance
1. Unplug the appliance and remove the detachable stem.
Note: Do not immerse the detachable stem of the blender in water because overtime
the lubrication on the bearings may wash away.
2. Wash the detachable stem under running water, without the use of abrasive cleaner
or detergents. After finishing cleaning the detachable stem, place it upright so that
any water which may have got in, can drain out. The stem is dishwashing safe
component.
3. Wash the cup, and blade in warm soapy water.
4. Wipe the motor unit with a damp cloth. Never immerse it in water for cleaning as a
electric shock may occur.
5. Dry thoroughly.
Caution: Blades are very sharp, handle with care.
6. Reassemble the blender shaft to motor unit then place it upright in wall
Bracket or hang it up for saving space.
Quick cleaning
Between processing tasks, hold the hand-held blender in the cup half filled with water and
turn on for a few seconds.
Fixing wall racket
You can fix the wall bracket as following:
1. Drill two same holes in wall and strictly follow the dimension
2. Knock two plastic tubes in them with hammer.
3. Secure the bracket on wall with another two screws.

7
Environment friendly disposal
You can help protect the environment!
Please remember to respect the local regulations: hand in the non-working electrical
equipments to an appropriate waste disposal centre.