ADAPTER MODULE LOAD CELL
CONNECTOR CONFIGURATIONS
#XXXX-XXX
7602008 - REVD
POINT®
Quick Start Guide
QUICK START GUIDE:
Quick Start Guide
PACKAGE CONTENTS
1POINT Unit
2
Adapter Module
3
TOOLS REQUIRED
#4 Phillips Screwdriver 2Android 7.0 or iOS 12.2 Device
1
*NOTE
PRODUCT SETUP
ASSEMBLE UNITS
Remove both the POINT unit and adapter
module from packaging. Slide the adapter
module into the rails located on the back
and bottom of the POINT unit.
When the adapter is flush and
in place, use a #4 Phillips
screwdriver and tighten the 4
captive screws.
12
1
2MOUNTING OPTIONS
The POINT unit mounts to three different systems:
Rail Mount, V-Plate Mount & Ram Mount. Refer to the
illustration below that matches the mount you have.
Rail Mount
1
Ram Mount
3
V-Plate Mount
2
To mount the Ram Mount,
remove the hardware from
the Rail Mount and secure
the Ram Mount to the rear
of the enclosure.
*NOTE
APP DOWNLOAD
Your mobile device must be connected to the internet
to complete this step. Download the Scale-Tec
POINT mobile app. Register and log into the app.
4
CABLE CONNECTIONS
Plug power and load cell cables into the
Adapter Module. Refer to the connector cable
that matches your specific adapter module (as
indicated on packaging). Do not turn on the
unit until you have completed Step 4.
3
Power Load
Cell
Auxiliary
Port
GPS
Port Power
Cable
Load Cell
Cable
AMP
M12 CROWN
DT6
POWER ON
Press the power button to
power on the device.
BASIC INDICATOR OVERVIEW
Press to power on.
Press and hold for 3
seconds to power off.
Press and hold
for 3 seconds to
zero the scale.
Power Button Zero Button
ACTIVATE DEVICE WITH APP
WARNING: Never charge your
tractor battery with POINT
connected to power source.
This will void your warranty.
To correctly calibrate POINT, it is required
to connect your profile to your POINT unit
through the mobile app. Open the POINT
app on your mobile device and follow the
on-screen prompts to create your profile
and complete the setup process.
6
After connecting to POINT, you
will be notified if there is a
firmware update available. If you
see this notification, follow the
prompts to install the update.
*NOTE
If the POINT unit displays
UNLOAD or LOAD at the bottom
of the screen on initial power up,
press the square stop button to
place POINT into Gross Mode.
*NOTE
5
12
34
Search for “Scale-Tec
POINT” to download from
the Google Play Store.
Search for “Scale-Tec
POINT” to download from
the Apple App Store.
Use this Quick Start Guide to help you get set up and running
immediately. Refer to our online help center at scale-tec.com for
more information on operating your POINT scale indicator.
Scale-Tec
POINT
ANDROID iOS
POINT mobile app and internet
connectivity to Android or iOS
device is required for initial set
up. However, internet service
(Cellular data/WiFi) is not
needed to function in the field.
