Scallywag Kids 3 Drawer Chest User manual

- 1 -
Assembly Instructions
3 Drawer Chest
BOTTOM
RHSIDE
LHSIDE
TOP
PLINTH
COMPONENTS;
1 x RH side
1 x LH side
1 x Bottom
1 x bottom plinth
1 x Top
2 x 3mm thick back
panels
Doors in Box 2
3 X Drawer base
1 x box fittings
(contents as below)
Tool required
8 x cam bolt
A
12 x 8mm
dowel (pre-
inserted into
panels)
B
8 x cam
C
1 x“H”
profile rear
panel
connector
D
6 x rear panel
connector
Please read & check through these instructions carefully before
proceeding with assembly.
This product is designed to conform to the latest safety regulations and we hope you will be happy
with your purchase. Whist every effort is made to ensure this product reaches you in good
condition, in the unlikely event you find a problem with any component, please do not attempt to
assemble –and contact your retailer. As you will appreciate, we cannot accept liability for damage
once an attempt to assemble has been made.
CLEANING: - A damp cloth should be sufficient to keep this product in good order. Please do not attempt to use
abrasive cleaning materials, as this will incur damage. Thank you for choosing our product. We hope you will be happy
with your purchase.

- 2 -
Bottom
Plinth
B
B
B
B
B
B
B
C
A
A
bottom
side
C
1. Press fit plinth into underside of bottom,
locating pre-inserted plinth dowels (B) into holes
in bottom panel.
2. Insert cam bolt A to 5mm holes on sides.
Insert cam C to 15mm holes on top & bottom.
Turn cams clockwise to lock
F
A
A
A
A
C
C
C
C
3. Using rear panel connector strip (D), slide
back panels into groove at the rear of the
carcass. They will be a little proud at the top –
this will slot into top later.
4. With care, lay the top upside down on a clean
surface to insert cam bolt (A) into the four 5mm
holes.
Insert the cam (C) into the 15mm holes at the top
of sides. Carefully fit the top to the sides –ensure
the back slots into the groove on the top. Lock the
cams by rotating clockwise as before.

- 3 -
Cabinet back panel
5. Fix the white rear panel connectors by placing
the small white lip between the back panel and
the unit, then screwing diagonally into the unit as
shown opposite.
Position the connectors: two to the top and
bottom and one into each side at approximately
half way.