Scallywag Kids Bookcase User manual

- 1 -
Assembly Instructions
Bookcase
BOTTOM
RH SIDE
LH SIDE
TOP
PLINTH
FIXED SHELF
COMPONENTS;
1 x RH side
1 x LH side
1 x Bottom
1 x bottom plinth
1 x fixed Shelf
2 x Adjustable shelf
1 x Top
2 x 3mm thick back
panels
Drawers in Box 2
1 x box fittings
(Contents as below)
Tool required
16 x cam
bolt
A
31 x 8mm
dowel (pre-
inserted into
panels)
B
12 x cam
C
4 x nickel
plated cam for
drawer front
H
8 x brass
shelf
support
D
1 x“H” profile
rear panel
connector
F
38mm
confirmat
M
Please read & check through these instructions carefully before proceeding
with assembly.

- 2 -
Shelf
Bottom
Plinth
B
B
B
B
B
B
B
B
B
B
B
C
C
A
A
bottom
side
1. Press fit plinth into underside of bottom,
locating pre-inserted plinth dowels (B) into holes
in bottom panel.
2. Insert cam bolt A to 5mm holes on sides.
Insert cam C to 15mm holes on shelf and
bottom. Lay sides on back edge and fit bottom
& shelf. Turn cam clockwise to lock.
RH SIDE
LH SIDE
F
3. Using rear panel connector strip (F), slide back panels into groove at the rear of the
carcass. They will be a little proud at the top –this will slot into the robe top later.

- 3 -
RH SIDE
LH SIDE
TOP
C
C
C
C
A
A
A
4. With care, lay the top upside down on
a clean surface to insert cam bolt (A) into
the four 5mm holes.
Insert the cam (C) into the 15mm holes at
the top of sides. Carefully fit the top to the
sides –ensure the back slots into the
groove on the top. Lock the cams by
rotating clockwise as before. Nearly there!
5. Insert shelf supports (D) where required and position shelves
Drawer Box Assembly
MM
HHHH
6. Assemble sides and back using 38mm Confirmat (M) Insert
cam (B) ready to take the drawer front.
7. Slide drawer base into
position

- 4 -
DRAWERFRONT
AA
H H
8. Place drawer front face down
on a clear surface to prevent
scratching –screw in cam bolts
(C) into the 5mm holes on the
inside of front.
Attach front to the box. Ensure
drawer base sits into the groove
on the front inside face.
Lock the front by turning cam (B)
in clockwise direction.
This product is designed to conform to the latest safety regulations and we hope you will be happy
with your purchase. Whist every effort is made to ensure this product reaches you in good condition,
in the unlikely event you find a problem with any component, please do not attempt to assemble –
and contact your retailer. As you will appreciate, we cannot accept liability for damage once an
attempt to assemble has been made.
CLEANING: - A damp cloth should be sufficient to keep this product in good order. Please do not
attempt to use abrasive cleaning materials, as this will incur damage.
Thank you for choosing our product. We hope you will be happy with your purchase.