HDMI KVM TX/RX over CAT5 XHDM210
Mouse & Keyboard Control up to 100m
Installation Instructions
HDM182 Transmitter
1. 5v DC power input 4. IR TX connection
2. UTP CAT5/6 output port (Max cable 100m) 5. USB port
3. HDMI input port 6. LED Power indicator
(Max HDMI cable length 5m for 1080P) 7. LED Signal indicator
(Max HDMI cable length 10m for 720P)
HDM192 Receiver
1. 5v DC power input 4. IR RX connection
2. UTP CAT5/6 input port (Max cable 100m) 5. USB port 1 for Mouse/Keyboard
3. HDMI output port 6. USB port 2 for Mouse/Keyboard
(Max HDMI cable length 15m) 7. LED Power indicator
8. LED Signal indicator
a) Connect an HDMI cable from the DVR, PS3 or DVD player etc. to the Transmitter.
Ensure that HDMI cable is no longer than 5 metres for a 1080P input signal or 10 metres for
a 720P input signal.
b) Connect the HDMI cable output from the Receiver to the HDMI monitor/HD TV Ensure
that the HDMI cable run is no longer than15 metres.
c) Connect a CAT5/6 cable between the Transmitter and Receiver no longer than 100 metres.
d) Connect a 5vDC 2A power supply to the Transmitter and Receiver. The power LEDS
should light up. When the signal LEDs light and flicker the equipment is ready to use.
e) If you are using a USB mouse or keyboard plug them into the USB ports on the Receiver.
You will also need a USB cable fitted between the Transmitter and DVR, or item you are
controlling with the mouse.
f) If you are using an IR remote, then connect the IR Receiver into the IR TX on the
Transmitter and the IR Transmitter into the IR RX on the Receiver. Ensure that the IR
Remote can see the IR Transmitter and the IR Receiver can see the IR sensor on the DVR.
