Schertler MAGNETICO AG6 User manual

Schertler SA
Via Beroldingen 18
6850 Mendrisio
Switzerland
T [phone]
F [phone]
[e-mail]
www.schertler.swiss
Facebook @schertler.sa
Instagram @schertleraudio
Youtube @Schertler SA
#shareyourschertler
QUICK GUIDE V1
M AG6
QUICK GUIDE
THANK YOU
FOR
CHOOSING
SCHERTLER
QUICK START
INSTALLATION
1. Position the MAGNETICO AG6 inside the
soundhole and push it as close to the end of the
ngerboard as possible. Make sure that the pickup
is perpendicular to the strings.
2. Turn both wheels counter-clockwise to x the
pickup to the soundboard. Take care not to
overtighten the clamps or you may damage the
guitar’s nishing.
The distance between the strings and the AG6
should be around 5mm (4mm is ideal). If the action
is higher you can raise the pickup placing a
thickness between the AG6 and the soundboard
before tighten the wheels.
3. Connect the 1/8” jack cable to the output.
CONNECTION
Now you can plug in your mono jack and discover
the pickup’s amazing sound.
USER GUIDE available at www.schertler.com
Scan the QR code
to open
the USER GUIDE

DYN AG6
RECOMMENDED POSITIONING
and WARNINGS
Contact surface
Glue must be placed
on this side.
Ideal position for
percussion style
WARNING!
Fix DYN AG6 by only
applying glue on the
inside of the guitar.
Any glue used on external
surfaces can damage the
guitar’s varnish.

Plug and unplug the 1/8” jack connectors with caution, and only if
necessary. These must be perfectly perpendicular when plugging/
unplugging.
Do NOT use MAGNETICO AG6 with STAT PRE preamp nor activate the
10V on preamps, amps and mixers as it will damage the pickup.
10V

RELATED PRODUCTS
ARTHUR
Mixer
ACOUSTIC
Amps
YELLOW
Preamps
DYN AG6
contact transducer
CA M EXT
External jack cable
S MIC
condenser microphone