Schiit REKKR User manual

DESKTOP SPEAKER AMP

1 Connect your source to the Rekkr’s “IN”
RCA jacks with high-quality RCA cables.
“Source” is a fancy word for headphone
amp or, preamp, or any other device that
has volume-controlled audio output.
2 Connect the supplied wall-wart cable to
the jack labeled “AC IN.” Do not use any
other wall-wart, or Rekkr will not work.*
3 Stereo: Connect the speakers to the “L”
and “R” outputs using banana plugs. En-
sure that the two switches on the bottom
are not set to “MONO.”
1
4 Mono: using the right RCA input only,
connect the speaker to the two middle
outputs with banana plugs. Ensure the two
switches on the bottom are set to “MONO.”
5 Turn on and off the power with the
power switch. Up is on. Down is off.
6 Make sure the Mono switches are set
correctly. Both towards “MONO” for mono,
both away from “MONO” for stereo.
*Rekkr’s wall-wart is AC output. Most AC adapters
are DC output, and will not work with Rekkr. Rekkr
works with a 6VAC, 2-4A output adapter only.
2
3
4
CONNECTIONS
35

1 Turn it on. The front LED will light up,
and the relay will click in after about 10
seconds. Then you’ll have music!
2 Control volume with your headphone
amp or preamp. You need a source with
a volume control. Don’t turn it up until it
distorts, or until your ears bleed.
PROTECTION
If your Rekkr clicks and mutes, clicks and
mutes, over and over, it is protecting itself
from over-current or over-temperature
situations.
Protection will happen when your speaker
cables are shorted or if there is a fault
in your speakers. Check your cables and
OPERATION
6
speakers for shorts, and try
different speakers.
You may also encounter protec-
tion when playing Rekkr loudly
for some time, or when using
low-impedance, low-eciency
speakers. Remember, Rekkr
is a relatively low-powered
amp, designed for desktop and
neareld use.

Schiit Audio warrants to the original purchaser that this product shall be free from defects in material and workmanship for two (2) years
from the date of purchase. If a defect covered by this warranty occurs during this period, Schiit Audio will repair the defective product, free
of charge. Date of purchase will be based on customer receipts, otherwise date of manufacturing will be used.
If you believe you need warranty service, contact us rst. Schiit Audio products sent back to us without a Return Authorization (RA) will
be returned to the sender without repair. To contact us and obtain an RA, email [email protected].
Warranty Limitations. This warranty shall not apply if a product: (a) is modied or tampered with; (b) is damaged by negligence, accident,
unreasonable use, or other causes unrelated to defective materials or workmanship, or (c) has had the serial number altered or removed.
Any implied warranties, including warranties of merchantability and tness for a particular purpose, are hereby limited in duration to the
warranty period of 2 years. In no event shall Schiit Audio be liable for consequential or incidental damages resulting from the breach of any
implied or expressed warranties. Some states do not allow these limitations, so they may not apply to you. You may also have other rights
which vary from state to state or province to province.
WARRANTY
SCHIIT.COM
[email protected]
1. If you don’t know how to install audio devices, get a qualied professional to help.
2. Never use this device near water, do not expose to rain or moisture, and clean only
with a dry cloth.
3. Assure adequate ventilation, do not block ventilation openings, or place near heat sources.
4. Use only the supplied wall-wart or suitable replacement. Route cords away from trac areas and
protect them from being pinched. Unplug the wall-wart from the outlet if the apparatus is unused
for a long period of time.
5. To prevent electric shock, do not use the plug with an extension cord, receptacle, or outlet unless
blades can be fully inserted.
6. Refer all servicing to qualied service personnel. Service is required when the device has been
damaged, including cord or plug damage, liquid has been spilled or objects have fallen into the device,
the device has been exposed to rain or moisture, does not operate normally, or has been dropped.
SAFETY
IN THE BOX
(1) Rekkr
(1) Wall-Wart
6VAC, 2A
(And maybe some
stickers, and the
appreciation of the
production, QC, and
engineering staff at
Schiit Audio in Texas
and California.)
This product is in compliance with standards
and regulations of the European Community.