Schumacher Electric SL27 Series User manual

Models
SL27 SERIES
Cordless LED Work Light
OWNER’S MANUAL
PLEASE SAVE THIS OWNER’S MANUAL AND READ BEFORE EACH USE.
This manual will explain how to use the work light safely and effectively .
Please read and follow these instructions and precautions carefully.
Contact the equipment supplier
for details on how to properly dispose of this product .

1. IMPORTANT SAFETY INSTRUCTIONS
SAVE THESE INSTRUCTIONS.
1.1 SAVE THESE INSTRUCTIONS – This
manual contains important safety and
operating instructions.
1.2 Read, understand and follow all
instructions, cautions and warnings
listed in this manual. Failure to follow all
instructions and abide by all cautions and
warnings could result in personal injury,
injury to others and property damage.
1.3 IMPORTANT! CHARGE WORK LIGHT
IMMEDIATELY AFTER PURCHASE,
AFTER EACH USE, AND AT LEAST
EVERY 3-6 MONTHS.
1.4 DO NOT turn on the work light while it is
being charged.
1.5 DO NOT handle or move the work light
while it is being charged.
1.6 DO NOT cover or block the lens during use.
1.7 DO NOT look directly into the light or
shine the light directly into the eyes of any
person or animal.
1.8 DO NOT allow children to use the work light.
1.9 DO NOT operate the work light if it has
received a sharp blow, been dropped, or
otherwise damaged in any way; take it to
a qualied service person.
1.10DO NOT leave the battery in a
discharged state.
1.11 WARNING! Do not use any other chargers
except the ones provided to charge
the internal battery. Use of a charger
not supplied by Schumacher®Electric
Corporation may result in a risk of re, injury
to persons and/or damage to property.
1.12 DO NOT use the work light with a charger
which has a damaged cord or plug,
replace the cord or plug immediately.
1.13 IMPORTANT! Make sure the voltage
marked on the charger plug is the same
as the work light.
1.14 To reduce the risk of damage to the
charger plug, pull by the plug, rather than
the cord when disconnecting the charger.
1.15 DO NOT use the provided charger to
charge or power any other electrical item.
1.16 DO NOT immerse the work light in water.
1.17 AC CHARGER FOR INDOOR USE ONLY.
DO NOT expose the AC charger to water
or use in damp conditions.
1.18 Ensure the work light is unplugged and
allowed to cool before attempting any
cleaning or replacement.
2. PERSONAL SAFETY PRECAUTIONS
WARNING! TO REDUCE THE RISK OF
BURNS OR FIRE, FOLLOW THESE
SAFETY PRECAUTIONS:
2.1 DO NOT open or disassemble the work
light; take it to a qualied service person
when service or repair is required. Incorrect
reassembly may result in a risk of re.
2.2 DO NOT crush, puncture, short external
contacts or dispose of in re or water.
2.3 DO NOT expose to temperatures above
140°F (60°C).
2.4 Replace the battery pack ONLY with one
designed for this product.
2.5 Recycle or dispose of the used battery
as required by local regulations. DO NOT
dispose of with household waste.
2.6 If the electrolyte in the cells gets on
your skin, wash thoroughly with soap
and water. If it gets into your eyes, rinse
thoroughly with cool water and seek
immediate medical attention.
2.7 This product contains a lithium ion
battery. In case of re, you may use
water, a foam extinguisher, Halon,
CO2, ABC dry chemical, powdered
graphite, copper powder or soda (sodium
carbonate) to extinguish the re. Once
the re is extinguished, douse the
product with water, an aqueous-based
extinguishing agent, or other nonalcoholic
liquids to cool the product and prevent the
battery from re-igniting. NEVER attempt
to pick up or move a hot, smoking, or
burning product, as you may be injured.
2.8 WARNING: This product contains one
or more chemicals known to the State
of California to cause cancer and birth
defects or other reproductive harm.
3. SETUP INSTRUCTIONS
3.1 Remove any cord wraps and uncoil the cable between the charger and the work light.

4. FEATURES
1. Charging status LED indicator
2. SMD LEDs (30)
3. Rocker switch:
HIGH (II) / OFF (O) / LOW (I)
4. Charging input jack
5. Thumb screws
6. 12V DC car charger
7. 100-240V AC wall charger
1 2
3
456 7
5. CHARGING
IMPORTANT! CHARGE THE WORK
LIGHT IMMEDIATELY AFTER
PURCHASE, AFTER EACH USE, AND
AT LEAST EVERY 3-6 MONTHS.
Failure to do this will reduce the battery’s
capacity and may void the warranty.
5.1 Before charging, make sure the rocker
switch is in the OFF (O) position. Failure
to do so will damage the charger plug/
vehicle plug.
5.2 Using the AC wall charger:
Insert the end of the AC charger cable into
the input jack on the back of the work light.
Plug the AC charger into a live AC outlet.
5.3 Using the 12V DC car charger:
Insert the end of the 12V DC car charger
cable into the input jack on the back of the
work light. Plug the 12V DC car charger into
a 12V DC power outlet.
NOTE: Charging the work light from a
12V vehicle socket will drain the vehicle’s
battery, unless the engine is running.
5.4 Plug into your power supply. The charging
LED will light RED, to indicate charging has
begun.
5.5 Charging will take approximately 4-6 hours.
When the battery is fully charged, the
charging LED will change to GREEN.
5.6 When fully charged, unplug the charger
from the AC or DC outlet, and then from
the work light. The work light is now ready
for use.
5.7 Recharge the work light after use, and at
least every 3-6 months.
6. OPERATING INSTRUCTIONS
6.1 IMPORTANT: Charge the internal battery
before use. Make sure the rocker switch is
in the OFF (O) position.
6.2 Press the rocker switch on the back of the
unit to turn on the work light to HIGH (II),
OFF (O) or LOW (I).
6.3 The position of the main body can altered
by loosening the thumb screws and moving
the main body.
6.4 ING
7. MAINTENANCE INSTRUCTIONS
7.1 After use and before performing
maintenance, unplug and disconnect
the work light.
7.2 Ensure the work light is unplugged and
allowed to cool before attempting any
cleaning.
7.3 Any servicing should be performed by
qualied service personnel.

8. STORAGE INSTRUCTIONS
8.1 Store inside, in a cool, dry place.
8.2 Take care to avoid/prevent damage to the
chargers, cords and unit. Failure to do so
could result in personal injury or property
damage.
8.3 Charge the work light’s internal battery
immediately after purchase, after every use
and every 3-6 months.
8.4 All batteries are affected by temperature.
The ideal storage temperature is at
70°F. The internal battery will gradually
self-discharge (lose power) over time,
especially in warm environments. Leaving
the battery in a discharged state may
result in permanent battery damage. To
ensure satisfactory performance and avoid
permanent damage, charge the internal
battery every 3-6 months.
9. TROUBLESHOOTING
PROBLEM POSSIBLE CAUSE SOLUTION
The work light does not
operate.
The battery is not charged.
The battery may be bad.
Recharge the battery to full
charge.
Have the battery replaced by
a qualied service technician.
10 SPECIFICATIONS
Battery type............................................................................ Lithium Ion, 7.4V, 4000 mAh
Lumen output...........................................................................High: 1000 lm; Low: 400 lm
LEDs ...................................................................................................................... 30 SMD
Operating time ..................................................................... High: 3.5 hours; Low: 8 hours
Charging time.......................................................................................................... 5 hours
Ingress protection rating ..............................................................................................IP54
Wall charger:
Input....................................................................................100-240V AC, 0.45A, 50-60Hz
Output .............................................................................................................. 12V DC, 1A
Car charger:
Input........................................................................................................................12V DC
Output .......................................................................................................................5V DC
11. REPLACEMENT PARTS
Wall charger......................................................................................................93026956Z
Car charger....................................................................................................... 93026957Z
Check out the collection of portable work lights we offer.