Science First Therm Bath III User manual

SCIENCE FIRST®| 86475 Gene Lasserre Blvd., Yulee, FL 32097 | 800-875-3214 | www.sciencefirst.com | [email protected]
©2010 - v 4/10
SCIENCE FIRST®| 86475 Gene Lasserre Blvd., Yulee, FL 32097 | 800-875-3214 | www.sciencefirst.com | [email protected]
699-9950 (70-150) Therm Bath III
(110 volt)
Important Safeguards:
• Pleasereadallinstructions.
• Donottouchhotsurfaces.Donotpickup
wheninuse.
• Toprotectagainstelectricalshock,donot
immersecord,plugsorunitinwaterorother
liquid.
• Unplugunitwhennotinuseandbeforeclean-
ing.Allowunittocoolbeforeproceeding.
• Donotoperateunitwithadamagedcordor
plug,oriftheappliancemalfunctionsorhas
beendamagedinanymanner.ReturntoSci-
enceFirst®forexamination,repairoradjust-
ment.
• Donotuseoutdoors.
• Donotletcordhangoveredgeoftableor
counterortouchhotsurfaces.
• Donotplaceonornearahotgasorelectric
burner,orinaheatedover.
• Donotmoveappliancewhenlledwithhot
liquids.
• Donotuseapplianceforotherthanintended
use.
• Todisconnect,switchtheunit"OFF",then
removeplugfromwalloutlet.
Updated features:
•Digitallycontrolledtemperaturesetting
•TemperaturereadsinFarenheitandCelsius
•Temperaturerange:77°Fto176°F
(25°C-80°C)
•Digitallycontrolledtimerwithautomatic
shut-off
•StyreneLiner
•Spatula
Maintenance:
• Thefuseisaccessibleviathebackpanelfuseholder.
**Unplugthewaterbathbeforeremovingthefuse.To
removethefuse,opentheblackfuseholder,located
justabovetheplugoutletandpullouttoremovethe
fuse.Replacefuseifnecessary.
• Thewaterreceptacleisnotremovable.Cleanoften
withanysuitablestainlesssteelcleaner.(Werecom-
mendScience First® 29-0701 Stai-Clean15oz.
aerosolspraystainlesssteelcleaner.)
Caution: Do
not immerse
in water
Corrosionshouldnot beaproblemsincetheunitis
constructedof18-8nickel-bearingstainlesssteel.The
waterreceptacleissealedbelowtherimsothataccidental
spillageispreventedfrompenetratingtotheinside.
How To Use:
1.)Fillreservoir toalevelwhichwillallowthewater
torisewithoutoverowingwhenthelargestobjectisim-
mersed.**Important: To avoid damage, always keep
water level at least half full.
2.)Connectto110-120v 60 Hz outlet.
3.)TurnunitonbypushingRockerSwitchlocated
belowredLEDlamp.TheRockerSwitchwillstayil-
luminatedaslongasitisinthedownposition.
4.)Tosetthedesiredtemperature,pressthe"Set"but-
ton.Theentiredisplaywillbegintoash.Pressthe"up"
and"down"keysuntilthedesiredtemperatureisreached.
Pressthe"Set"buttonagaintolockinthenewtempera-
ture.Thedisplaywillnowshowthesettemperaturein
theupperrightcorner.Itwillread"Set:(temperature)".
5.)Whenthethermbathisheating,thedisplaywill
read"heating"andshowthecurrenttemperatureinthe
mainpartofthedisplay.TheredLEDlampabovethe
rockerswitchwillilluminatewhentheunitisheating,
andgodarkwhentheunitisholdingtemperature.
Description:
Thenewandimprovedthermbathisnowadigital-
ly controlledwarm-waterbath.Useforanyprocedure
wheremedium heat isrequired.
Thethermbathiscapableofheatingfrom77°Fto
176°F.TheunitcanbeconvertedtodegreesCelsius
(25°C-80°C)bythetouchofthe"F/C"buttton.

©2010 - v 4/10
SCIENCE FIRST®| 86475 Gene Lasserre Blvd., Yulee, FL 32097 | 800-875-3214 | www.sciencefirst.com | [email protected]
Accessories:
1.YourLaboratoryWaterbathwillacceptacustom-made
strongpolystyrene0.40plasticlinertotthe699-9950
sink.Itcanbewashedinadishwasheronthetopshelf
andreusedseveraltimes.Additionallinersareavailable
directlyfromScience First®.
2.[Optional]Youmaywishtouseathermometertocheck
temperaturesettings.Youmayorderonesuitedtothis
applicationfromScience First®. Theunithasabuiltin
thermometerandwilldisplaytemperatureonthescreen.
699-9995Thermometer
3. 699-9991Stai-Cleanstainlesssteelcleanerisrecom-
mendedforusewiththeLaboratoryWaterbath.Itis
availabledirectlyfromScience First®.
Further Problems:
Iftheunitdoesnotheatupafteranextendedperiodof
cooling time, then the heating element may have failed.
PleasecontactScienceFirstforanRMA(returnmerchandise
authorization)numberandsendtheunitbacktoScienceFirst
toobtainanestimateforrepairs.
P/N 24-7150
©ScienceFirst®.ScienceFirst®isaregistered
trademark of Morris & Lee Inc.All rights
reserved.
Contact us: info@sciencerst.com
or phone: [phone]
Warranty and Parts:
Wereplacealldefectiveormissingpartsfreeofcharge.
Additional replacement parts may be ordered toll-free.
We accept MasterCard, Visa, checks and School P.O.s.
Allproductswarrantedtobefreefromdefectfor90days.
Doesnotapplytoaccident,misuseornormalwearandtear.
Intendedforchildren13yearsofageandup.Thisitemis
notatoy.Itmaycontainsmallpartsthatcanbechoking
hazards.Adultsupervisionisrequired.
6.)Whenthedesiredtemperaturehasbeenreached,the
displaywillread"holding"andshowthecurrenttempera-
ture.
7.)Onthebottomofthedisplayreads"Autooff:x.xH".
Thisshowshowmuchtimeisleftbeforethethermbath
automaticallyturnsitselfoff.
8.)Toadjustthetimer,pressthe"Set"button.Next,
pressthe"Mode"button.Youcannowusethe"up"and
"down"keystoadjustthetimer,accuratetothetenthofan
hour.Pressthe"Set"buttonagaintolockinthenewtime.
9.)Takecarenottoheattheunitwhendry!Ifyoudo
this,runawayheatingmayoccur.Theunitwillautomati-
callyshutitselfoffat190°F,butsuchhightemperatures
candamagetheinternalsofthethermbath.Alwaysmake
surethereiswaterinthesinkbeforeheating.
Troubleshooting:
Problem: Theunitwillnotheat,andthelightdoesnot
comeon.
Likely Cause: Thefusehasblown.
Solution: Important!Unplugthe unit before servicing
thefuse. Thefuseisaccessibleviathebackpanelfuseholder.
Toremovethefuse,opentheblackfuseholder,locatedjust
abovetheplugoutletandpullouttoremovethefuse.Replace
fuseifnecessary.
Problem: Theunitwillnotheat,andthelightdoescome
on.Likely Cause: Thesafetythermostathasbeentripped.
Solution: Thesafetythermostatwillre-setitselfonce
ithassufcientlycooled.Dependingonconditions,itmay
takeupto30minutes.Theprocesscanbespeededupby
llingthesinkwithcoldwater.