SCORPION ERS WATCH DISPLAY User manual

INSTRUCTIONS
ERS WATCH DISPLAY
Before installing, check to make sure Scorpion
axle is NOT locked
Tel: [phone]
www.scorpionsp.com
[e-mail]
1. Install base. Place washer under counter on display
bolts and use provided nuts to tighten.
NOTE: Do not over tighten
2. Run charging cable through pedestal.
3. Insert the security key into the axle of the Scorpion and
rotate counter-clockwise to open the legs wide enough for the
device to fit in the Scorpion. Place charging cable and set
watch on top.
4. Place the device into the Scorpion and ensure that the
leveling plate is aligned to the center of the device.
NOTE: Leveling plate may need to be lowered in order to fit watch in.
(see step 7) You may need to insert watch at slight angle.

1. To lock down, place the installed device into the
receiver. Press the lock in to secure and double check
that the Scorpion is locked into place.
TO INSTALLAS LOCK DOWN
6
8. After securing the leveling plate, go back and tighten
the side legs. There will no longer be a gap between the
screen and legs when the leveling plate has been
properly raised. Tuck watch band in designated slot.
6. Tighten the side legs of the Scorpion until they slightly
touch the side of the device by inserting the security key into
the axle and rotate clockwise.
7. Raise the leveling plate by inserting the security key
into the leveling plate studs. Switch back and fourth
between the studs to ensure equal pressure.
9. To lock the axle, insert the security key into the center
of the Scorpion body located on the back side of the
device. Turn the security key clockwise to tighten the
screw and lock the axle into place.
NOTE: Do not over tighten
NOTE: Alternate 3 turns per stud until plate is raised
5. Align the watch with the center of the leveling plate.