Scully Connect User manual

Scully Connect®Testing Cable
(P/N 092000240)
User Guide
This cable accessory is designed to be eld repairable. If any part of the
cable breaks, it can be repaired using the instructions provided.
If a wire breaks on the banana plug end of the cable:
1. Unscrew the fastening termination screw inside
the banana plug and remove any broken pieces
of wire that may be stuck inside.
2. Strip away a ¼” length of insulation from the wire
where it is broken.
3. The exposed wire can be tinned with a soldering
iron or twisted and left as is.
4. Insert the wire into the banana plug and fasten
it using the termination screw.
If a wire breaks on the Scully Connect®end of the cable:
1. Insert and push a thin, blunt tool into the connector.
2. Remove any broken pieces of wire that may be
stuck in the connector.
3. Strip away a ¼” length of insulation from the
wire where it is broken.
4. The exposed wire needs to be twisted and
tinned with a soldering iron.
5. Insert the wire into the connector and ensure
that it is properly inserted by gently tugging
on the repaired wire.
603000004 Rev A
November 2018
FIELD REPAIR
Scully Signal Company
70 Industrial Way, Wilmington, MA 01887-3479, USA
800 272 8559 • 617 692 8600 • [e-mail]
U.K.
[phone]
[email protected]
Europe
[phone]
[e-mail]
India
[phone]
[e-mail]
1
1
4

Connect the banana plugs of the cable to the Scully Universal Truck
Tester (UTT) unit following the 5-Wire OPTIC color code.
Turn on the unit, and set the sensor type to “OPTIC” for 5-Wire sensors
or “THERMISTOR” for 2-Wire sensors.
Connect a single Scully Connect 2-Wire or 5-Wire sensor to the other
end of the cable using the appropriate connector.
5-WIRE CONNECT®
If a 5-Wire sensor is working as expected, the UTT will display a ashing
red light for compartment 1 and show a “GOOD” status with a green
light in the optic test display.
INSTRUCTIONS DISPLAY
OPTIC TEST INDICATORS
COMPARTMENT INDICATORS
8 7 6 5 4 3 2 1
FAIL POOR GOOD
2-WIRE CONNECT®
If a 2-Wire sensor is working as expected, the UTT will display a green
light for compartment 8 in the THERMISTOR section of indicator lights
THERMISTOR TEST INDICATORS
8 7 6 5 4 3 2 1
GOOD
POOR
FAIL
THERMISTOR
COMPATIBLE
6 5 4 3 2 1
OPTIC TEST INDICATORS
COMPARTMENT INDICATORS
8 7 6 5 4 3 2 1
FAIL POOR GOOD
THERMISTOR TEST INDICATORS
8 7 6 5 4 3 2 1
GOOD
POOR
FAIL
THERMISTOR
COMPATIBLE
6 5 4 3 2 1
RED BLACK
GROUND
ORANGE YELLOW GREEN
POWER
THERMISTOR
OPTIC
5-Wire Connect®Sensor
2-Wire Connect®Sensor
1
1
2
3
3
2