Sea-doo UTOPIA 205 SE Manual

Lmo2005 utopia suppl.FH8 Tue Oct 05 13:23:50 2004 Page 1
204 630 319

Dear Utopia®205 SE Owner, This Supplement contains additional informa-
tions not included in the 2005 Operator's Guide 204 630 319) that may ap-
plies to your boat model.

TABLE OF CONTENTS
VEHICLE INFORMATION
CONTROLS, COMPONENTS AND INSTRUMENTS FUNCTIONS ...... . .... 4
Tower ............................................................................. 4
Depth Finder ..................................................................... 6
Stereo Remote Control.......................................................... 6
______________________ 1

VEHICLE
INFORMATION
______________________ 3

CONTROLS, COMPONENTS AND INSTRUMENTS
FUNCTIONS
Tower
The Utopia®205 SE has a model
available with a tower for skiing/wake-
boarding.
F21L28Y
CAUTION: Always tow the vehicle
with the towing tower fastened in
the upright position to avoid dam-
age to the boat and towing vehi-
cle while in transport.Tower must be
secured and in the upright position
to avoid damage to the boat. Peri-
odically check that bolts are in place
and tight. Check clearance height
around docks, shore, overhanging
objects, bridges and power lines.
The tower must not be used as a
tie-down or tie-off point.
To clean the tower, use isopropyl alco-
hol and a clean soft cloth.
To fold tower for storage, remove
knob below, from each side of tower.
F21L29Y
1
1. Remove this knob
Carefully fold tower forward until stor-
age pad is in contact with bow.
Remove knobs from curved exten-
sions on each side of tower.
F21L2BY
1
1. Remove this knob
Lower both support arms into position
shown below.
F21L2AY
TYPICAL
4_______________________

Place knobs in glovebox or other se-
cure storage for later use.
Raising of tower is the reverse of this
procedure.
Tower Removal
NOTE: This procedure will require
two people. Remove tower only from
upright position.
To completely remove tower from
boat, remove both rear attachment
knobs from tower and remove the
8 mm (5/16 in) Allen bolt from each
front tower upright. Carefully remove
tower from boat.
Installation (from off boat)
NOTE: This procedure will require
two people.
Carefully lift tower assembly and posi-
tion front supports in their attachment
points.
Apply Loctite 243 (P/N 293 800 059)
to threads of bolts and install bolts into
front attachment points. Torque bolts
to 12 N•m (106 lbf•in).
Lift support arms into position and in-
stall knobs.
Raise tower into upright position and
install knobs to complete installation
of tower.
WARNING
Pulling a tube, skier or wakeboard-
er makes the boat handle different-
ly and requires greater skill. Un-
less absolutely necessary, do not
make tight, sharp turns. Keep a
safe distance from docks, swim-
mers, other craft or objects. Be ad-
vised that serious injury can result
if the tow rope becomes slack dur-
ingatightturnorwhencircling.
The rope could become wrapped
around the neck or limbs of a per-
son.
The decal shown below is installed on the tower and on the gunwale next to the
driver's seat.
F13L1PL
WARNING
______________________ 5

Depth Finder
A depth finder is included as standard
equipment with the Utopia 205 SE and
is located on the dashboard.
F21H07Y
Please refer to included manufactur-
er's instruction sheet for depth finder
operation.
Stereo Remote Control
A remote control for the AM/FM CD
stereo is included as standard equip-
ment with the Utopia 205 SE and is lo-
cated on the dashboard.
F21H06Y
Please refer to included manufactur-
er's instruction sheet for remote con-
trol operation.
6_______________________