Seaira Global STORM ELITE User manual

Tools Needed:
•Philips Head Screwdriver
•Replacement Sensor
1. First, undo the side and base latches so you can open the cover.
2. Next, you will need to remove the cover from the control board. Use the screwdriver
to remove the two screws at the top of the cover.
Seaira Global • 14021 NC Highway 50 • Surf City, NC 28445
www.seairaglobal.com
How To Replace the Control Board
Storm ELITE
Control Board
Remove
Screws

3. At this point, you will need to unplug the following wires on the control board (starting
in the upper left corner and moving clockwise).
•Power (black with blue cover)
•Compressor (white with blue cover)
•Fan (white)
•Hot Gas Bypass (black)
•Pump (white and black)
•Display (white with red)
•RH sensor (black)
•Coil Temp. Sensor #1 (red and blue)
•Coil Temp Sensor #2 (red and blue
•Pump #1 (black and red)
•Pump # 2 (black and red)
•Power (black with blue cover)
•Compressor (brown with blue cover)
4. Once the wires are unplugged, you can lift the the control board out of the
machine. To do this, you will need to use the needle nose pliers. Use the pliers to push in
Seaira Global • 14021 NC Highway 50 • Surf City, NC 28445
www.seairaglobal.com

the 4 “arrowhead” tabs (one in each corner). Simply squeeze each tab with the pliers
so the control board can be lifted over the tab.
5. Now you’re ready to set the old control board aside and insert the new one.
Carefully set the replacement control board in place, ensuring the tabs secure into
place.
6. Next, reinsert the wires into the control board.
7. Once the wires are plugged in, screw in the control board cover, and close the
machine.
Seaira Global • 14021 NC Highway 50 • Surf City, NC 28445
www.seairaglobal.com

Seaira Global • 14021 NC Highway 50 • Surf City, NC 28445
www.seairaglobal.com