Seaira Global WatchDog NXT60 User manual

Tools:
•Phillips Head Screwdriver
-OR-
•#2 Phillips Drill (Optional)
•Replacement Control Board
1. Remove the side panel so you have access to the control board (the side with the sensor
vents). For more details, check out the “How to Remove the Side Panels” Guide.
2. Remove the two screws from the control board cover and lift off the cover.
How to Change the Control Board
Seaira Global • 14021 NC Highway 50 • Surf City, NC 28445
www.seairaglobal.com
WatchDog
NXT
60

3. At this point you will need to unplug the wires from the control board.
4. Next, use a screwdriver to remove the 4 screws holding the control board in place (one in
each corner).
Seaira Global • 14021 NC Highway 50 • Surf City, NC 28445
www.seairaglobal.com

5. Finally, lift the control board out and set aside. Insert the replacement control board. Reverse
the process to install the board- insert the screws, rewire, and replace control board cover.
Seaira Global • 14021 NC Highway 50 • Surf City, NC 28445
www.seairaglobal.com