SEASIDE CASUAL FURNITURE 046 User manual

1
Tools Required:
Phillip's Head Screwdriver
4MM Allen Wrench (Included)
(046) Portsmouth Dining Table rev. C
(56In x 56In),
WOOD ENVIRO
SEASIDE CASUAL FURNITURE
Hardware:
46 (16) 3” Hex 1/4” Lags
(16) 3/4” Pan Head Screws
(1) Table Top Assembly
Parts List:
Assembly Instructions
Step One: Set Up
READ ENTIRE INSTRUCTIONS BEFORE BEGINNING! Carefully remove contents
from box. Make sure that all parts and hardware are included. Place Table Top upside down on
a flat clean surface.
Place Leg Stretchers between both Leg Assem-
blies aligning pre-drilled holes. Attach each end
of both stretchers using (2) 3” Hex 1/4” Lags
(Right Picture).
Step Two: Leg Stretchers
WARRANTY QUESTIONS OR COMMENTS PLEASE CALL TOLL FREE AT 1-800-809-3114
Instruction Revision: B
(2) Leg Assemblies
(2) Leg Stretchers
(2) Short Aprons
(2) Long Aprons

2
Step Three: Apron Assembly
Step Four: Apron Attachment
Place Apron Assembly on to Leg Assembly
aligning pre-drilled holes in the Aluminum
and Legs (Left Picture). Attach using (4) 3”
Hex 1/4” Lags (Right Picture).
Place Short Aprons between Long Aprons aligning pre-drilled holes.
Attach using a 3” Hex 1/4” Lag on both sides of each Short Apron.
Step Five: Base Attachment
Place Base Assembly upside down and square on to the Table Top
Assembly. Align Apron ends and sides with the center of the Table
Top Assembly. Attach using (16) 3/4” Pan Head Screws.