SEASIDE CASUAL FURNITURE Portsmouth User manual

1
Tools Required:
Phillip's Head Screwdriver
7 /16 Socket or Wrench
4MM Allen Wrench (Included)
(44,45) 3Ft, 4Ft Portsmouth Bench rev. A
WOOD ENVIRO
SEASIDE CASUAL FURNITURE
Hardware:
(6) 3-1/2” Connector Bolts
(6) Lock Washers
(6) Flat Washers
(6) Nuts
(6) 3” Hex 1/4” Lags
(45 Only) (8) 3” Hex 1/4” Lags
(6) 5/8” Plugs
(4) 1-3/4” Phillip’s Head Screws
(1) Back Assembly
Parts List:
Assembly Instructions
Step One: Set Up
READ ENTIRE INSTRUCTIONS BEFORE BEGINNING! Carefully remove contents
from box. Make sure that all parts and hardware are included.
Place Seat Assembly face down on a flat
clean surface. Place Side Leg Assembly
along outside of the Seat Support, while
aligning pre-drilled holes (Left Picture). In-
stall using (2) 3-1/2” connector bolts. Fin-
ger tighten using flat & lock washers and
nuts (Right Picture). Do not tighten at this
time. Repeat process on other side.
Step Two: Side Leg Assembly
WARRANTY QUESTIONS OR COMMENTS PLEASE CALL TOLL FREE AT 1-800-809-3114
(1) Seat Assembly
(2) Angle Seat Braces
(2) Side Leg Assemblies
(45 Only) (1) Leg Stretcher
Instruction Revision: C

2
Tighten all connections. Do not over tighten!!! Over tightening of hardware can cause
damage to the item. Plug all holes. Using (6) 5/8” Plugs.
Step Six: Tightening of Hardware
Step Three: Back Assembly
Place Chair in standing position. Place
Back Assembly aligning pre-drilled holes
on both ends allow Back Assembly to lean
against the ground. Attach using (2) 3-1/2”
connector bolts. Finger tighten using flat &
lock washers and nuts (Left Picture). Flip
Back Assembly up into position. Attach to
Seat Assembly using (6) 3” Hex 1/4” Lags
(Right Picture). Do not tighten at this time.
Step Four: Angle Brace Assembly
Position Angle Brace over second slat from rear (Left Picture). At-
tach using (2) 1-3/4” Phillip’s Head Screws. Repeat process for other
brace.
Step Five: Front Leg Stretcher (45 Only)
Place Front Leg Stretcher along all Mid Leg Braces aligning pre-
drilled holes. Attach using (2) 3” Hex 1/4” Lags.