SECO-LARM Enforcer Relay Module SR-2224-C5 User manual

®
●Switch selectable (see chart below) DC voltage output.
●Regulated and filtered output voltage.
●Switches to backup battery automatically in case of power loss.
●Short circuit protection.
●Built in backup battery charger.
Four Models to Choose From
Model #
ST-1206-1.5A
ST-2406-2A
ST-2406-3A
ST-2406-5A
Voltage (DC) Current Current (peak)
6,12
6,12,24
6,12,24
6,12,24
1.5A
1.5A
2.5A
4.0A
2.0A
2.0A
3.0A
5.0A
●Triggered by positive voltage (+DC), closure of dry contact, or
opening of dry contact.
●Set from 1 sec. to 60 min.
●Relay programmable to activate at start or end of timing cycle.
●Relay programmable for pulse (flash) activation.
●Built in reset function.
●Form C relay, contacts rated 8A @ 120VAC/24VDC.
●LED indicator.
●12/24VDC (auto sensing).
●Low current drain.
●2 7/8" x 2 1/2" (73 x 63 mm).
SA-025
Power input
Current drain
Relay type
Contact rating
12/24VDC (auto en ing).
Low
Form-C relay
8A @ 120VAC/24VDC.
Model Number:
Relay type:
Relay contact ratings:
Supply Voltage:
Current draw:
Programmable 6/12/2 VDC,
default at 12VDC
70mA @ 12-2 VDC
100mA @ 6VDC
SR-2224-C5
ENFORCER
Relay Module
Specifications:
Tel: [phone] (Domestic U.S. & Canada) Tel: [phone] (California & international)
Fax: [phone] Email: [e-mail] Website: www.seco-larm.com
SECO-LARM
®
U.S.A., Inc.
16842 Millikan Avenue, Irvine, CA 92606
RelayModuleb.p65
SR-2224-C5
DPDT, Form-C dry contacts
5A @ 250VAC/30VDC
®
ENFORCER
Power Supplies
®
ENFORCER
Timer Modules
Red LED - lights to show
relay is energized
2 Jumpers to
program
input voltage
(6,12,2 V)
Input terminals to energize relay
Connection Diagram
Two separate sets of Form-C contacts
6V 12V 24V
JP1 ON ON OFF
JP2 ON OFF OFF
Preset 12V
+/- 20% of operating voltage
2.76" x 1.89" x .79"
(70 x 8 x 20mm)
1.9 oz. (55 g)
Foam tape (included)
Minimum pull voltage
Size
Weight
Mounting method:
Features:
••
••
• Two separate sets of Form-C dry contacts.
••
••
• Perfect for a variety of general switching purposes.
••
••
• Can be connected for load switching, dry contact, latching
output, reverse polarity, line seizure, and other uses.
••
••
• 6 12 24 VDC operation, programmable by on-board
jumpers.
••
••
• Red LED indicates relay is energized.
••
••
• Large terminal blocks for easy installation.
••
••
• Small size, easily fits inside alarm panel enclosures
or other hidden areas.
••
••
• Foam mounting tape included.