Second Story Home Gatsby User manual

B O X C O N T E N T S
A.0H E A D BORDx 1
B.0FOOTBOARDx 1
C.0S I DE PANEL x 2
LEG S x 4D.0
E.0BOTTOM PANEL x2
F.0S I DE BRACKET x 4
G.0SUPPORT BRACKET x6
H.0WOODEN STABILIZER x 3
I. 0ALLEN BOLT 1” x28
ALLEN WRENCH x1
J .
0
B. QTY1
E. QTY2
F. QTY4
D. QTY4
C. QTY2
A. QTY1
G. QTY6
I. QTY28
J . QTY1
H. QTY3

WHAT YOU WILL NEED
C.0SIDE PANEL x2
F.0SIDE BRACKET x4
I. 0ALLEN BOLTS 1” x20
G.0SUPPORT BRACKET
ALLEN WRENCH x1J. 0
FIGURE 1
02
STEP: 01
STEP: 02
Set Side Bracket ( F ) on the Side Panel ( C ) as shown below in Example 1.
Place bracket so the two holes are against the Fabric. Next, place the 1”

shown in Example 2. DO NOT OVERTIGHTEN.

SEE FIGURE 1
SEE FIGURE 2


DO NOT OVERTIGHTEN.
FIGURE 2

wHAT YOU WILL NEED
03
A.0HEADBOARD
B.0FOOTBOARD
H.
0
WOODEN STABILIZER x3
D. LEGS x4
0
I.
0
ALLEN BOLTS x8
J. ALLEN WRENCH
SIDE PANEL W/ BRACKETS INSTALLED
STEP04
STEP 05
STEP 03
WITH BOTH THE HEADBOARD (A) AND FOOTBOARD ( B ), USE THE REMAIN-
ING 8 ALLEN HEAD BOLTS ( I ) TO SCREW INTO FOUR BOTTOM HOLES ON
EACH OF THE PIECES. LEAVE THESE BOLTS LOOSE.
STEP 05
STEP 04
STEP 05
TAKE THE HEADBOARD ( A ) AND ALIGN THE BOLTS
TO THE SIDE BRACKET ( E ) THAT IS ALREADY
ATTACHED TO ONE OF THE SIDE PANELS. ONCE
PLACED INSIDE THE HOLE, PRESS DOWN TO LOCK
THE BOLT IN PLACE. DO SO UNTIL BOTH THE HEAD-
BOARD ( A ) AND FOOTBOARD ( B) ARE ATTACHED
TO THE SIDE PANELS ( C ). ONCE ALL PIECES ARE
ATTACHED, BEGIN TO TIGHTEN EACH OF THE
BOLTS USING THE ALLEN WRENCH ( J ).
FLIP OVER THE TODDLER BED WHEN YOU’VE FINISHED
ASSEMBLING THE FOUR PIECES OF THE BED TOGETHER.
ONCE IT IS FLIPPED ON IT’S SIDE, BEGIN TWISTING THE
LEGS ( D ) INTO THE SIDE BRACKETS.
WHEN FINISHED WITH ALL FOUR LEGS, FLIP OVER SO THAT
THE BED IS NOW STANDING ON IT’S LEGS. PLACE BOTH
WOODEN STABILIZER ( I ) INSIDE THE STABILIZER BRACKET TO
SECURE THEM IN PLACE.
STEP 06
0 3

wHAT YOU WILL NEED
04
I. 0BOTTO M P A N E L x 2
STEP 07
THE LAST STEP TO BUILDING THE GATSBY TWIN BED IS TO LAY THE
BOTTOM PANELS DOWN, SIDE BY SIDE, ONTO THE WOODEN SUPPORTS.
CHECK ALL BOLTS TO BE SURE THAT THEY ARE SECURED BEFORE
PLACING MATTRESS DOWN.
CARE AND MAINTENANCE
PERIODICALLY CHECK YOUR BED FOR ANY LOOSE BOLTS AND SCREWS AND TIGHTEN WHERE NEEDED. IF BED IS DAMAGED, DO NOT
USE. CONTACT US FOR REPLACEMENT PARTS. SPOT CLEAN ONLY. AVOID EXCESS MOISTURE.
PLEASE VISIT OUR WEBSITE AT WWW.SECONDSTORYHOME.COM THERE, YOU CAN FIND MORE PRODUCT INFORMATION,
REGISTER YOUR PRODUCT, CONTACT US OR REQUEST REPLACEMENT PARTS.
YOU CAN EMAIL OR WRITE
[email protected]
SECOND STORY HOME
1477 DAVRIL CIR
CORONA, CA 92878
ONE YEAR LIMITED WARRANTY
CONTACT US
DEFECTIVE PARTS WILL BE REPLACED WITH A ONE YEAR PERIOD FROM DATE OF ORIGINAL PURCHASE. MISSING PARTS WILL BE
REPLACED WITHON 30 DAYS FROM THE DAY OF ORIGINAL PURCHASE. SECOND STORY HOME WARRANTS ONLY NEW UNITS
PURCHASED IN IT’S ORIGINAL PACKAGING. THE WARRANTY DOES NOT COVER USED, SECOND HAND OR DEMOS AND IS
NON-TRANSFERABLE.
ANY DAMAGED OR DEFECTIVE PART THAT RESULTS FROM NORMAL WEAR AND TEAR, ABUSE, NEGLIGENCE, IMPROPOSER USE OR
ALTERNATION TO THE FINISH, DESIGN AND HARDWARE OF THE BED, OR THE ASSEMBLY OF THIS PRODUCT ARE NOT COVERED. THE
SPECIFIC LEGAL RIGHTS OF THIS WARRANTY MAY VARY FROM STATE TO STATE. SOME STATES DO NOT ALLOW ANY EXCLUSION OR
LIMITATION OF INCIDENTAL OR CONSEQUENTIAL DAMAGES. SOME STATES DO NOT ALLOW LIMITATIONS ON HOW LONG AN
IMPLIED WARRANTY LASTS.
BOTTOM PANELS