Teknik 5420275 User manual

Industrial Style Coffee Table
Model 5420275
www.teknikoffice.co.uk
NOTE: THIS INSTRUCTION
BOOKLET CONTAINS IMPORTANT
SAFETY INFORMATION.
PLEASE READ AND KEEP FOR
FUTURE REFERENCE.
Guaranteed to hold
other beverages, too.
Teknik

Table of Contents
3
3
4-5
Part Identification
Hardware Identification
Assembly Steps
Page 2
Assembly Tools Required
No. 2 Phillips Screwdriver
Tip Shown Actual Size
Skip the power trip.
This time.

Part Identification
åWhile not all parts are labeled, some of the parts will have a label or an inked letter on the edge
to help distinguish similar parts from each other. Use this part identification to help identify similar parts.
A END (2)
B TOP (1)
C BOTTOM (1)
D BRACE (4)
Now you know
our ABCs.
Page 3
Hardware Identification
åScrews are shown actual size. You may receive extra hardware with your unit.
A
B
C
A
D
D
ALLEN WRENCH - 1
4
1-3/8" ALLEN SCREW - 8
11-3/16" ALLEN SCREW - 4 2
1-1/8" SCREW - 4
3
D

Step 1
å Assemble your unit on a carpeted floor or on the empty carton
to avoid scratching your unit or the floor.
å NOTE: Start all of the SCREWS before tightening any of them.
å Fasten the ENDS (A) to the BRACES (D). Tighten eight 1-3/8"
ALLEN SCREWS (1) using the ALLEN WRENCH (4).
å Square up the BRACES (D) to the ENDS (A).
å Completely tighten all of the SCREWS.
Page 4
1-3/8" ALLEN SCREW
(8 used in this step)
1
A
D
A
D
D
D
4

å Fasten the TOP (B) to the ENDS (A). Tighten four 1-3/16" ALLEN SCREWS (2) into the threaded inserts in the TOP
using the ALLEN WRENCH (4).
å NOTE: Start all of the SCREWS (2) before tightening any of them.
å Fasten the BOTTOM (C) to the ENDS (A). Use four 1-1/8" SCREWS (3).
å NOTE: Do not overtighten the SCREWS (3).
å Carefully stand your unit upright.
å NOTE: Please read the back pages of the instruction booklet for important safety information.
å This completes assembly. Clean with your favorite furniture polish or a damp cloth. Wipe dry.
Step 2
Page 5
1-3/16" ALLEN SCREW
(4 used in this step)
2
B
A
A
Surface
with holes
C
Surface
with holes
1-1/8" SCREW
(4 used in this step)
3
50 lbs.
40 lbs.
4