Secure Wireless EV-F319 User manual

LOW BATTERY INDICATION
LED will flash to indicate that Low Battery Supervision
has been sent and the battery should be replaced.
WARRANTY
Secure Wireless offers a Lifetime Warranty on this
product. Secure Wireless agrees to repair or replace this
product at no cost to the user. For return authorization
please contact: Secure Wireless
1185 Park Center Drive, Suite A/B
Vista, CA 92083
[phone]
This device complies with part 15 of the FCC Rules. Operation is subject to
the following two conditions: (1) This device may not cause harmful
interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation.
4 Button Wireless Transmitter
For use with Part #s: EV-F319/EV- F345/EV-F433
USER MANUAL
Button 1
Button 3
Button 2
Button 4
6658-SW-Evol Manual 10/7/02 10:05 PM Page 1

I . Programming the Remote
into the Alarm System
Refer to the programming guide that came with your
alarm system for programming a wireless device
(KEYFOB) into the security system.
II. Changing Panic Operation
to Delay Mode or Instant Mode
Note: To use this feature you must have programmed
button 4 into the alarm panel as “PANIC”. The 3 second
delay is the factory default.
SETTING PANIC BUTTON FOR
DELAY TRANSMISSION MODE
(By selecting this feature, the user must hold down panic
button for 3 seconds before transmission is sent.)
1. Press all 4 button at the same time until the LED
begins to flash. (This will take approximately
3 seconds before LED flashes.)
2. Release all 4 buttons
3. Press Button 2 (TOP RIGHT BUTTON)
4. LED should stop flashing
SETTING PANIC BUTTON INTO
INSTANCE TRANSMISSION MODE
1. Press all 4 button at the same time until the
LED begins to flash. (This will take
approximately 3 seconds before LED flashes.)
2. Release all 4 buttons
3. Press Button 1 (TOP LEFT BUTTON)
4. LED should stop flashing
6658-SW-Evol Manual 10/7/02 10:05 PM Page 2