sedia systems JumpSeat Series User manual

Parts Included
Tools Required
Seat
Fixed Base
Movable Base
Hardware Included
1/4"
Masonry
Drill Bit
Power Drill
7/16" Nut Driver
(Concrete)
1/4"x 25/8"
Concrete Anchors
5/32"/ 4mm
Allen Wrench
Concrete
Anchor Caps
12
3
3/8"x 21/2"
Lag Screw
Lag Screw
Caps
4
5
9/16" Nut Driver
(Wood)
JumpSeat®

Concrete Floor
• Position base on oor and mark hole locations.
• Punch or cut carpet to avoid runs.
• Drill 1/4" holes approximately 3" deep.
• Use concrete anchors to attach base to oor.
• Install bolt caps.
• Position base on oor and mark hole locations.
• Punch or cut carpet to avoid runs.
• Use lag screws to attach base to oor.
• Install bolt caps.
• Loosen bolts on lower front panel with supplied
allen wrench.
• Slide JumpSeat over mounting base until contact
is made with base plate.
• Tighten bolts with supplied allen wrench.
3
1
Minimum 7"
From Wall
2
4
5
Wood Floor
Floor Installation
JumpSeat®
Mininmum 7"
From Wall