SENKO Blow alcohol User manual
Blow alcohol
Better drinking culture for you
Blow alcohol User Guide
WARNING
Do not measure immediately after drinking. An inaccurate
concentration of alcohol in the mouth will be measured, not in the
blood.
The device must be kept in a well-ventilated place after use.
If the concentration of high alcohol is re-measured continuously, it
may affect the accuracy of the measurement result.
If the surrounding environment is contaminated, stabilization for
measurement may not be accurate.
Alcohol sensors are vulnerable to silicone / rubber / volatile
materials, so please be careful.
At the time of measurement, please be careful not to let any
matter (saliva or other substances) enter the sensor part from the
mouth of the tester.
In general, alcohol concentrations are highest between 30
minutes and 1 hour after drinking, and this time may change
depending on the food eaten. Therefore, please note that the
blood alcohol level may change over time.
This product has been precisely adjusted during manufacture, but
it may not work properly if it got shocked or wet during use.
If this product is modified or changed arbitrarily, it may cause
malfunction.
Drunk driving might cost disaster, so do not check whether you
can or cannot drive based on the measurement results of this
product after drinking.
Use this product for reference only to your blood alcohol level and
do not try to drive based on the measurement results of this
product.
The head office informs the driver that he is solely responsible for
any accidents caused by drunk driving, and the manufacturer,
distributor and supplier are not responsible for any accidents.
1. Product Overview
3
Blow alcohol User Guide
2. Activation & Use
4
Blow alcohol User Guide
2.1. Download the app and sign up
- Download the Blow app from by the QR code or
from your phone's app store or Google Play.
- After downloading the Blow app, go through the
login process.
2.2. Turn on the power and connect to Bluetooth
- Press the power button next to the device's strap.
- After login is completed, by turning on the power, the mobile
phone and the device will automatically connect via Bluetooth.
2.3. Measuring
- The mouth of the device will wound by hand.
- Inhale as deeply as possible and stop for about 3 seconds.
- Then, breathe out (blow) as longer as you can.
- Lastly, measurement data can be checked through the blow
app.
5
Blow alcohol User Guide
3. Specification
Display
Measuring range
0.000~0.250% BAC
Accuracy
±
10% Based on standard wet
alcohol (0.030% BAC)
Sensor
Electrochemical
Power
Button
1 button (On/Off)
Battery
Rechargeable Lithium polymer
(100mAh)
Battery life
In continuous use, 100 tests
Charge time
1 hour (built
-
in protection circuit)
Charger
DC5.0/1A (USB Type
-C)
Measuring
Initial re
-
measure
time
Within 1 minute
Expiration time
3 seconds
Exhalation time
Within 10 seconds based on
10% BAC
Re
-measurement
time
Within 10 seconds (Pass/Fail)
Connection
BLE 4.1 (Bluetooth Low Energy)
Temperature
0
°C ~ 36°C (32°F ~ 96.8°F)
Dimension
95 x 29 x 27 mm
(3.74 x 1.14 x 1.06 inch)
Weight
50g
Approval
SGT-P User’s Manual
Limited Warranty
SENKO warrants this product to be free of defects in workmanship and materials-under normal use
and service for 6 months from the date of purchase from the manufacturer or from the product’s
authorized reseller.
The manufacturer is not liable (under this warranty) if its testing and examination disclose that the
alleged defect in the product does not exist or was caused by the purchaser’s (or any third party’s)
misuse, neglect, or improper installation, testing, or calibrations. Any unauthorized attempt to repair
or modify the product, or any other cause of damage beyond the range of the intended use,
including damage by fire, lightening, water damage or other hazard, voids liability of the
manufacturer.
In the event that a product should fail to perform up to manufacturer specifications during the
applicable warranty period, please contact the product’s authorized reseller or SENKO service
center at 82-31-492-0445 to repair/return information.
73, Oesammi-ro 15 beon-gil, Osan-si, Gyeonggi-do, 18111, South Korea
Tel : 82-31-492-0445 Fax : 82-31-492-0446
6
Table of contents
