Sennheiser SET 55 TV Operator's manual

Sennheiser electronic GmbH & Co. KG Phone [phone] Printed in China
30900 Wedemark, Germany Fax [phone] Publ. 10/06
www.sennheiser.com 517641 / A02
A
B
C









Connecting the system components
 Plug in one end of the connecting cable  to the socket on your sound source (e.g. television).
If necessary, use one of the adapters  ,  or  (not included) .
Plug in the other end of the connecting cable  to the blue socket  on the transmitter.
 Connect the mains unit to the transmitter and to the mains.
 Place the receiver into the transmitter’s charging compartment .
 Before you use the rechargeable battery for the first time, charge it for at least 14 hours.
 Adjust the volume of your sound source to a sufficient (medium) level.
Switching on and using the stethoset receiver
 Turn the volume control  in the direction of “ON” until it clicks.
 First adjust the volume to a low level. This protects your hearing from damage.
Then put the receiver on and adjust the volume to a comfortable level.
 Use the balance control 쐋to adjust the volume between the left and right ear.
 If you cannot hear anything through the receiver, increase the volume of your sound source.
Switching off the stethoset receiver
 To switch the receiver off, turn the volume control in the direction of “OFF” until it clicks.
Charging the stethoset reciever
 Switch the receiver off. Place the receiver into the transmitter’s charging compartment without
exerting too much pressure. With a fully charged battery, the operating time is approx. 9 hours.
For details on the use of the Set 50 TV/Set 55 TV, please refer to the enclosed operating instructions.
Set 55 TV
Set 50 TV
Quick instructions