SENSIRION EK-P4 User manual

Quick Start Guide
EK-P4

Quick Start Guide EK-P4
1Install FTDI USB driver for the sensor cable.
(http://www.ftdichip.com/Drivers/VCP.htm)
3Connect the USB sensor cable to the sensor PCB and the PC.
4Start up the USB RS485 Sensor Viewer.
5Under COM Hardware, select «RS485/USB Sensor cable».
6Select the sensor product «Sensirion Flow Meters (SF06 Chip)».
2Install software after download from: www.sensirion.com/USB-viewer

7Select COM port and press «OK». Highest COM port is most often correct.
9Press «Run».
8The SF06 Viewer appears. Adjust the following settings first:
§Change units to «Pascal».
§Set scale factor to 60.
§Set sampling time to 1ms or more.
§Enter command HEX 0x3603.

160600-EK-P4
SENSIRION AG
Laubisruetistrasse 50
8712 Staefa
Switzerland
Phone + 41 44 306 40 00
Fax + 41 44 306 40 30
[email protected]
www.sensirion.com
For more information about Sensirion's differential pressure
sensors of the SDP3x series, please visit www.sensirion.com/sdp3x or
contact our technical customer support team:

X-ON Electronics
Largest Supplier of Electrical and Electronic Components
Click to view similar products for Pressure Sensor Development Tools category:
Click to view products by Sensirion manufacturer:
Other Similar products are found below :
MPRSS0001PG00001CB 1075 MIKROE-2293 166 SEN0068 EVALSHNBV01TOBO1 MIKROE-2550 SEN-09673 SEN0066
DPP101G000 DPP901G000 2651 3965 4258 4414 4494 4633 4816 NPA-201-EV EVAL-CN0295-EB1Z SEN0251
MPRLS0001PG0000SAB MPRLS0015PA0000SAB MPRLS0025PA00001AB MPRLS0300YG00001BB SEK001 KP254PS2GOKITTOBO1
KP215F1701PS2GOKITTOBO1 KP236PS2GOKITTOBO1 KP275PS2GOKITTOBO1 MAXREFDES82# DPP101A000 MERITREK
MIKROE-3328 MIKROE-3411 MIKROE-3466 MIKROE-3566 MIKROE-3603 MIKROE-4127 MIKROE-4142 MIKROE-4149 MIKROE-
4190 MIKROE-4294 MIKROE-1489 MIKROE-1817 MIKROE-1880 MIKROE-2065 MIKROE-2237 MIKROE-3020 MIKROE-3030