Sercomm Wingle User manual

1
Sercomm Wingle
Quick Start Guide
Document Version: 1.0
Sercomm Copyright 2019. All Rights Reserved.

Sercomm Copyright 2019. All Rights Reserved 2
.
Wingle Quick Start Guide
1Overview
The Adventure Wingle is a LTE modem in addition to a 2.4G Wi-Fi router. When the device is
connected to an external power adapter or when using mobile power, it can provide a Wi-Fi
connection for up to 8 devices which includes tablets, smartphones and other gaming devices
using the 4G LTE mobile network. The Wi-Fi interface supports 802.11 b/g/n.
2Interfaces
The following figure illustrates the appearance of the device.
1. USB Connector (5V/500~1000mA)
2. Wi-Fi LED
3. LTE LED
4. SIM Card Slot
5. Antenna
Table 2-1 Descriptions of the indicators
Indicator
Status
Description
Wi-Fi LED
None
Power Off
Amber
SIM card error. SIM card is not inserted or PIN locked.
Blue
Wi-Fi connection is established.
LTE LED
Amber
Connected to LTE network with poor signal quality.
Green
Connected to LTE network with good signal quality.
Blue
Connected to LTE network with excellent signal quality.

Sercomm Copyright 2019. All Rights Reserved 3
.
3Installation
1. Detach the SIM card cover from the device.
2. Insert the SIM card (not included) into the card slot.
Note: Make sure the SIM card is properly installed. Do not remove the SIM card while
the card is in use, otherwise it may get damaged.
3. Re-attach the SIM card cover on the device.
4. Prior to powering the device, make sure to adjust the antenna orientation to the
appropriate position to ensure the best performance.
5. Insert the device into the USB port of your computer.
4Network Configuration
The configuration webpage can be accessed if RNDIS driver is installed successfully. The
RNDIS driver is supported by MAC OS and Window 7/10. If your machine does not have
RNDIS driver installed, please check OS vendor website for help. For Linux OS, please check
if RNDIS driver is available. To support Linux CDC-ECM/CDC-EEM driver, please contact
with Sales for assistance.
Starting the Configuration Program
1. Connect the device to the USB port of the laptop/PC.
2. Start your web browser.
3. In the Address box, enter HTTP:// 192.168.0.1:8080 (default IP Address).

Sercomm Copyright 2019. All Rights Reserved 4
.
4. Enter the login name and password. If using the default values, enter the data on the
product label for the name and password. LTE information page will show after login.
5. Click LTE - Setting - APN Table. Configure PDN type and enter the APN Name for
configuration if required.