Serenity Square 3 Tier Cascading Water Feature User manual

1
Square 3 Tier Cascading Water Feature Instruction Manual
For correct usage, please read these instructions carefully before first use and store in a safe place
for future reference.
After Sales Support
Call 0871 911 7031
Email
[email protected]
Product Code: G4638
Thank you for purchasing this
product, which has been made to high
quality standards and is guaranteed for
domestic use against manufacturing
faults for a period of 12 months from
date of purchase

2
Safety warnings and general information
•Use this product only in accordance with the instructions.
•Children should be supervised to ensure that they do not play with product.
•This product is not a toy.
•Keep the product and its power cable out of reach of children.
•Before cleaning and when not in use unplug from the mains supply.
•Do not handle the electrical components with wet hands.
•Do not use the appliance with a damaged power cord or plug.
•To avoid hazards, ensure that any electric cable is safely out of the way of children and
pets.
•Where possible ensure all power cables are positioned away from footfall areas.
•It is important that an RCD (Residual Current Device) is present, and any product of this
type is connected to it.
•When removing re-positioning or replacing the water pump make sure the power is off
and the plug is out of the socket.
•Repairs to electrical equipment should only be performed by a qualified electrician.
Improper repairs may place user at serious risk.
•Always use the original power cable supplied with the product.
•Make sure the voltage on the rating label matches the mains power supply to be used.
•Do not unplug by pulling the power cable.
•Water temperature must not exceed 35°C. Top the water levels up frequently during hot
weather.
•In very low temperatures, drain, dry and protect the water feature from frost, snow and
ice.
•This product is designed for outdoor use only and should not be positioned where water
spillage may damage carpets or furnishings.
•Always position on a flat level surface.
•The chosen location should be free from overhanging trees and bushes which may shed
their leaves in autumn.
•Ensure that the water level is always sufficient; do not allow the pump to run dry.
•To eliminate the possibility of water damage around your water feature, check for leaks
and excessive splashing after the initial setup.
•Do not leave your water feature running for extended periods of time unattended.
•Occasionally the water pump may make excessive noise, this may be due to the pump
rattling against the side of the reservoir or a small amount of trapped air. Always ensure
that the pump is suckered to the base using the rubber feet. Remove any trapped air by
gently shaking the water pump.
•This water feature is not suitable for commercial purposes.

3
Locating the water feature
•Position the base on a suitable firm, level surface away from areas where it is likely to
become clogged with leaves or debris, which could damage the pump.
•Unpack the components and lay out on a flat surface.
•Check there is enough cable to reach the plug socket.
•Ensure the feature is only placed on surfaces that will not get marked or damaged by
water splashing. If placing on wooden decking, ensure that the base surface has been
sealed or treated as appropriate. Place in a location where any water spills or splashing
will not reach any other electrical equipment or cause damage.
Assembly
Reach inside the opening in the rear or
side of the water feature, pulling out
the tubing/water pipe and internal
LED cable(s), (if the water feature is
supplied with lights –not available on
all models)
Connect the tubing to the outlet of
the pump and place it in the water
reservoir through the opening in the
rear or top of the water feature; secure
to the base of the reservoir using the
suckers to prevent the pump from
moving around

4
If your water feature is supplied with
lights, connect the two ends of the
LED lighting wires together and screw
over the plastic collar. Push the cable
with two pins into the transformer
and screw over the plastic collar
Place the pump and excess wires into
the access cavity, ensuring that the
long pump and LED wires extend out
through the opening
Carefully fill the fountain with
sufficient clean, cold tap water
ensuring the pump is fully submerged

5
Adjusting the flow of the water
The flow of the water can be adjusted by turning the dial on the water pump.
Care and maintenance
•Keep water clean and free from debris. If debris gets caught in the pump, disconnect it
from any power sources and rinse the pump under clean running water.
•Clean the water feature periodically to prevent build-up of mineral deposits on the sides
and base. Use a stiff brush and clean warm water with a little liquid soap. Do not use
detergents or abrasives as this will damage the surface of your water feature.
•Frost can cause damage to the pump. The pump must be removed and stored in a frost-
free environment if the water is likely to freeze.
Connect the plug from the
transformer to your mains outlet
Water flow adjuster

6
GUARANTEE
IMPORTANT
Please do not return this product without first calling the Customer Service number
below:
0871 911 7031*
Thank you for purchasing this product, which has been made to demanding high quality
standards and is guaranteed for domestic use against manufacturing faults for a period of 12
months from the date of purchase.
This guarantee does not affect your statutory rights. If your product fails due to a defect in
material or workmanship during this period, please return it to the place of purchase. Normal
wear and tear is not covered under the guarantee.
Any guarantee is invalid if the product has been misused or subject to neglect or an attempted
repair other than by our own service centre.
Due to continuous product improvement, we reserve the right to change the product
specification without prior notice.
After Sales Customer Service:
Customer Service Department, Branded Garden Products Ltd, Premier House, Hortonwood 7,
Telford, TF1 7GP, UK
Telephone: [phone]*
E-mail [email protected]
Please retain for future reference.
Colours and contents may vary.
Waste electrical products should not be disposed of with household waste. Please recycle where
facilities exist. Check with your Local Authority or retailer for recycling advice.
Please note that all products with the symbol below must be recycled.
*Calls cost 13p per minute, plus your phone company’s access charge