Serpent CENTAX TRUE MOTION User manual

E
1
Bag
14
E
2
TRUE MOTION CLUTCH
INSTRUCTION MANUAL
& EXPLODED VIEW
Note 1: to align the clutchgears with the 2-speed gears,
it may be needed to use shim(s) 7x13x 0.5mm
behind the cone.
This you can only see after assembly of the clutch.
Note 2: the holes in the side of the flywheel can be used
to block the flywheel (with short allen tool)
through the bottom of the chassis, when the
engine/clutch is mounted in the car.
It’s easier to tighten or loosen the pre-load on
the clutch spring that way.

E
3
E
4
A
B
E
5
screw in adjusting nut all the way
unscrew 1 1/2 turns
1st gear 2d gear
note orientation of the gears

E
6
E
7
use these shims to achive desired gap
SETTING THE CLUTCH GAP
A B
Small inner dia.
A
B
5.0mm5.2mm
IMPORTANT! Install thrust bearing
plates as shown
M3x16
check gap. gap should be between
0.5 and 0.6 mm

E
8
Exploded view Centax True Motion Clutch 1/8
Place small shims to remove all
but a small amount of end play
ADJUSTING THE END PLAY
www.serpent.com - [e-mail] © Serpent #1-2012
Sheet Centax True Motion clutch 1/8 : # 95653 1
6503
903399
903401 6582
110423
909514
1340
1315
903387
909559
909555
1377
909516
110107
110424
903400 6587XP 6584
909518 6583
sales part-number Centax True Motion clutch 1/8 # 903397