Severtson GP169 series User manual

Instruction Manual for
Portable Pull Up Series
MODEL: GP169XXX, GP1610XXX
Thank you for purchasing a Severtson projection screen.
Before use, please read the instructions carefully. After installation, store the instructions for future reference.

2
Overview
Front View (Closed)
Rear View (Partiall Extended)

3
Installation Instructions
Take out the screen from the packaging, then follow the steps below to install the screen.
1. ut the screen on the ground with the front side facing the projector. Rotate the two feet
into position to provide stable support (Figure 1).
2. ull the locking switch to release the screen (Figure 2).
3. Raise the screen by grasping the handle and pulling up to the desired screen position
(Figure 3).

4
Screen Operation
Use the handle to easily adjust height according to your preference.
Note:
To retract the screen, lower the screen back to the case using the handle until the locking
switch engages, then turn the feet back aligned with the case. The screen is then ready for
transport or storage.

5
Warnings
1. When installing the screen be sure to follow the instructions carefully.
2. Be careful not to scratch or damage the screen surface while handling it.
3. Do not write or draw on screen surface. Do not poke, fold, or tear screen material.
4. Do not use detergents or harsh chemicals to clean screen material. A soft cloth and mild
soap can clean dust and dirt off the screen material. A cotton cloth can be used to gently
wipe dust off of the frame.
5. Retract the screen to block out dirt and dust if it is not used for an extended period of time.
6. To prevent unnecessary damage, the assembly and maintenance of the screen should be
done by adults.

Severtson Corporation
216 S. Alma School Rd. Ste 3
Mesa, AZ 85210
Toll Free: 1-866-510-5155
hone: 1-480-610-5155 Fax: [phone]
Email: [e-mail]
Website: www.severtsonscreens.com