Shark DuoClean ION F80 User manual

QUICK
START
GUIDE
Please make sure to review the Shark® Owner’s Guide prior to using your vacuum. The
Guide is available online at sharkclean.com
IF281_QSG_REV_MP_180621
@sharkcleaning
MULTIFLEX STORAGEMULTIFLEX® REACH
EMPTYING THE DUST CUP
©2018 SharkNinja Operating LLC. SHARK is a registered trademark of SharkNinja Operating LLC. DUOCLEAN,
MULTIFLEX, SHARK ION, and SMART RESPONSE are trademarks of SharkNinja Operating LLC.
Refurbished by America’s Remanufacturing Company, an independent company not affiliated with
SharkNinja Operating LLC. This product is warranted and
supported by America’s Remanufacturing Company.
Press the MultiFLEX Lock Release
button and hold it down while folding
the handvac forward, until the
unit locks in storage mode.
To vacuum, press the MultiFLEX Lock
Release button while lifting up the
handvac, until the wand locks in place.
Press the MultiFLEX Lock Release
button to lower the angle of the wand
to increase your reach.
1. To empty dust
cup, first remove
the handvac from
the wand by
pressing the Wand
Release button
and pulling up on
the handvac.
2. Position dust cup
over a trash bin,
then open the
bottom of the dust
cup by pressing
the Dust Cup
Release button on
the side.
MultiFLEX
Lock Release
Carry Handle
Wand
Release
Wand Release
Button
Dust Cup
Release Button
R-IF281
Use this Quick Start Guide
to start using your
REFURBISHED vacuum’s
great features.
For questions, visit SHARK
online at sharkclean.com
Register your vacuum at
arcaugusta.com/register-
my-product.htm
IONTM F80
CORD-FREE MULTIFLEX®
REFURBISHED

ION
WHAT’S INSIDE: SMART RESPONSE™ TECHNOLOGY
ION POWER PACK
In Use
Full
Charge
Mid
Charge
Low
Charge
Nearly
Empty
No
Charge
Charging
Low
Charge
Mid
Charge
Nearly
Full
Full
Charge
Press the Surface Settings button to switch floor types. Press the ION BOOST button
to intelligently switch between ION POWER and ION BOOST.
Surface Settings Suction Settings
VERSATILE CHARGING
Easily Insert or Remove the ION Power Pack
To insert, slide the ION Power Pack into the slot in the back of
the hand vac.
To remove, pinch the release tab then slide out the ION Power Pack.
OUT OF THE VACUUMIN THE VACUUM
NOTE: ION Power Pack
comes with a partial charge.
Fully charge prior to first
use and then completely
discharge to condition
the pack.NOTE: Full charge takes approximately 3.5 hours.
Battery Indicator
Lights
CARPET
For carpets.
FLOOR
For bare floors and
small area rugs.
IN AVAILABLE
CHARGING DOCK
ASSEM B LY
For complete maintenance instructions, refer to the Owner's Guide.
For additional parts and accessories, visit sharkaccessories.com.
For additional batteries and charging accessories, visit sharkclean.com/batteries.
A
B
C
2
(Click)
3
(Click)
1
(Click)
Power Button
NOTE: For deep cleaning per ASTM F 608 (embedded dirt in carpets) please select CARPET and ION BOOST settings.
NOTE: Select Carpet setting for stuck-on dirt and debris.
ION POWER
For everyday cleaning.
ION BOOST
Press for a timed
1-minute boost of
increased suction for
high-trac areas and
heavy messes. Press and
hold for manual control
of ION Boost for as long
as you need it.
AHandheld Vacuum
BMotorized Floor Nozzle
CMultiFLEX®Wand
DUpholstery Tool
E8" Crevice Tool
FION Power Pack (x2)
GION Power Pack Charger
HION Power Pack Charging Dock
ED F
G H