ASSEMB LY
WHAT’S INSIDE MAINTENANCE
QUICK START GUIDE
Please be sure to read the enclosed Shark® Owner’s Guide prior to using your unit.
Insert wand into
motorized floor nozzle.
Using a coin,
turn locks
counterclockwise
to open, then
lift o cover to
access brushroll.
Replace cover,
pressing down
firmly on all sides
before turning
locks clockwise
to close.
Clear
blockages
from airway.
Place pod onto wand and
slide down to connect.
Connect hose to back of
pod, pressing until it clicks
into place. Store accessories
on the posts on the pod.
Insert handle into wand.
1
(Click)
2
(Click)
3
(Click) 4
(Click)
Empty dust cup after each use
TIP:
Wash foam and
felt filters every
3 months to keep
the suction strong.
Rinse filters with water
only and allow them
to air-dry completely.
Tap loose dirt from
foam filters as needed
between washes.
Cleaning Filters
Pull up on
dust cup
release latch
and lift dust
cup o pod.
Hold dust cup over
a trash bin and press
the empty-release
latch on the bottom.
HEPA
Felt filter
Foam filter
Filter
AWand
BMotorized Floor Nozzle
CHandle & Hose
DVacuum Pod
EPet Crevice Tool
FPet Multi-Tool
C
B
A
E
D
F
Press top
empty-release
latch to access
dust screen and
remove built-up
debris as required.
Pre-Motor (foam and felt):
With the dust cup removed, take out the foam and felt
filters and rinse them with water only.
Post-Motor (HEPA):
To access the HEPA filter, pull the Filter Access latch under
the filter cover and take o the cover. Remove the HEPA
filter and rinse it with water only.
Self-Cleaning Brushroll
The self-cleaning brushroll automatically removes hair wrap.
If some hair or debris remains after continued use, remove the
cover to access the brushroll.
POWERED LIFT-AWAY®
with Self-Cleaning Brushroll
