Sharper Image 204904 User manual

Congratulations on your purchase of the world’s #1 tie rack — the Sharper Image Motorized
Tie Rack! You have in your hands a modern and efficient way to store, organize and select your
favorite ties and accessories. Please take a moment to read these instructions and store them
for future reference.
• Easy to set up and use
• Holds up to 45 ties, plus 4 belts / accessories
• Fast installation: clamps on to any standard
closet rod in minutes
• Tightens easily with included Tension Screw
• 3 bright white LEDs illuminate your ties
• Suitable for all closet rods 1” to 1.3” in diameter
• No outlet needed: operates on 4 C batteries (not
included)
• Automatic shutoff to conserve batteries
Note: The Motorized Tie Rack is recommended for
closets at least 18” deep, with a minimum of 5” from
the rear edge of the closet rod to the back of the
closet. In addition, this device requires at least 1.25”
clearance above the closet rod.
- 1 -
FEATURES
Item No. 204904
User Guide
MOTORIZED TIE RACK

- 2 -
SET UP GUIDE BATTERY SAFETY WARNINGS
WARRANTY / CUSTOMER SERVICE
MOUNTING ON A CLOSET ROD
PRODUCT OPERATION
1. Insert the two Accessory Hooks (included)
on the bottom of the unit.
2. Remove the Battery Box Cover by sliding
it back.
3. Insert 4 C batteries (not included) making
sure the polarity (“+” and “-”) matches
the image inside.
4. Replace the Battery Box Cover.
5. Insert the Tension Screw into the bottom
of the unit and turn 2-3 times (do not
tighten it yet).
1. Do not mix old and new batteries.
2. Replace the entire set of batteries at the
same time.
3. Do not mix alkaline batteries and disposable
batteries.
4. Do not dispose of batteries in a fire. This may
cause them to leak or explode.
5. Never attempt to disassemble or open
batteries, as this can lead to electrolyte
burns.
6. Keep all batteries out of reach of children.
Sharper Image branded items purchased
from SharperImage.com include a 1-year
limited replacement warranty. If you have
any questions not covered in this guide,
please call our Customer Service department
at 1 [phone]. Customer Service
agents are available Monday through Friday,
9:00 a.m. to 6:00 p.m. ET.
1. Holding the device with the front side (with
lights) toward you, slide the black Cover Plate
to the right to remove it.
2. Align the unit under your closet rod. Make
sure the buttons are facing the front of the
closet.
3. Replace the black Cover Plate.
4. Tighten the Tension Screw until the device is
level and secure on your closet rod.
1. Press the Left button to rotate carousel
clockwise and turn on the LED.
2. Press the Right button to rotate carousel
counter-clockwise and turn on the LED.
3. Press the Stopper button to halt the rotation.
Note: The carousel and LED lights turn off
automatically to conserve battery power.
The SHARPER IMAGE® name and logo are registered trademarks.
©Sharper Image. All Rights Reserved.
Click Here to Read More....
Mobile friendly optimized manual:
Sharper Image Motorized Tie Rack Instruction Manual