FEATURES OF THE CV/SV ROUTING SWITCHER
This device can be operated in (2) modes: IR remote control or Manual mode. Modes can be selected by pushing the IR/Manual buttons
on the front panel to the video switcher. If you have (4) devices hooked up to the (4) inputs and only one has its power turned on, only
that device can be switched to the output via the IR remote control. When Manual mode is selected, the same can be done by pushing
the video select buttons on the front panel.
SINGLE SOURCE OPERATION
When only one source device, such as a VCR, is connected, always connect the device to the CV/SV Switcher’s AV1 input. Because AV1
is the default input, it will automatically be fed to the AV outputs when the CV/SV Switcher’s power plug is pulled out of the switcher. All of
video in/output selections will remain in switchers memory for as long as the power plug stays in the switcher. When the CV/SV switchers
power button is turned off, it will not reset any settings.
DUAL OUTPUTS
Both of the CV/SV outputs will have the same signal that has been selected by internal switching logic of CV/SV Switcher. These dual
outputs are provided for convenience.
SB-5430
Safeguards and Precautions
A. Keep this unit away from re, extremely hot areas, water or moisture of any kind.
B. Do not place this unit on any support that is not rm, level and strong.
C. Do not service the unit yourself. Opening the unit’s housing will void the warranty.
D. Servicing must be by Shinybow or by an authorized technician.
C. Illegal duplication of copyrighted material is strictly prohibited by Federal Laws.
FRONT VIEW:
Power SW: ON/OFF
IR: Remote Controller receiver
Video Select: Video 1~4 Buttons
REAR VIEW:
Input: (4) Composite/S-Video/Audio
Output: (2) Composite/S-Video/Audio
Power DC Supply: DC12V@420mA
