ShockWatch RC-17 User manual

[email protected] 1300 074 625 shockwatch.com.au May 2022
1. If the data logger has not been
stored at room temperature, place
it in room temperature for 30 mins
before starting.
2. Press and hold the START/STOP
button for approximately 5 seconds.
The green light ashes for 5 secs.
3. Place the data logger into
the location to be monitored.
Recording will begin after the start
delay period shown on the logger.
4. If there has been no temperature
excursion, the green light will
ash green every 10 seconds.
If a temperature excursion has
occurred, the red light will ash
every 10 seconds.
5. To stop recording, press and hold
the START/STOP button for 5
seconds. The red light ashes for 5
secs.
6. To generate a trip report, tear or cut
away the waterproof plastic bag. Be
careful not to damage the device
when cutting away the bag. Insert
the logger into a PC USB port. The
green and red lights will alternately
ash when the PDF report is being
generated.
7. When the PDF report has been
generated, the green and red lights
will illuminate solid until the logger
is removed from the USB port.
RC-17 Temperature Data Logger
User Manual
STATUS LED INDICATION
Does not Start Red and green light ash simultaneously
Start-up Delay Red and green light blinks alternately once
Start - Normal Green light blinks once ( ashes 10 times every minute)
Start - Alarm Red light ashes once (ashes 10 times every minute)
Start - Mark Red and green light ash 3 times at the same time
Start - Mark overrun Red and green light ash 3 times alternately
Stop - Normal Green light ashes twice
Stop - Alarm Red light ashes twice
OPERATION ACTION LED INDICATION
START Recording Press the START/STOP Button for 5 seconds The RECORD LED will blink 5 times
STOP Recording Press the START/STOP Button for 5 seconds The STATUS LED will blink 5 times
Status Indication
The status of the recording can be analyzed by the unit’s indicator light.

[email protected] 1300 074 625 shockwatch.com.au May 2022
Waterproof Plastic
Wrap
USB Port
LED Indicators
Button (Start/Status/
Mark/Stop)
Barcode Label
Conguration Info
Front Back
Start/Stop Info
Mark Info
Status Request
Paste Area
Temperature Measuring Range -30°C ~ +70°C
Resolution 0.1°C
Accuracy ±0.5°C (@-20°C~+40); 1°C/(@others)
Memory Capacity 16000 readings
Recording Period 6, 15, 30, 60, 90, 120, 180 days (customisable)
Alarm Type single or cumulative
Report Type PDF format
Data Interface USB2.0
Sensor type Internal NTC
Power supply Built-in CR2450 wide temperature lithium battery
Battery life 2 years (stored and used under normal temperature environment)
Protection grade IP67
Dimension 93mm (L) x 58mm (W) x 8mm (H)
Weight 20g
Specications
Log and Start Delay info

[email protected] 1300 074 625 shockwatch.com.au May 2022
Report Content
Download Data
Press the STOP button for
5 secs to stop logging.
The red light ashes 5
times.
Take the logger out of the
waterproof bag
Press the device into the
computers USB port to
view the PDF data report.