ShowStopper 240620 User manual

2/12Instructions Continued On Back Side
Product Specifications
Thermal Peak Maximum Imprint: 46" w x 17" h
Thermal Overhang Maximum Imprint: 60” w x 8” h
Dye Sublimation Size: Full Bleed, reference Artwork Template
Canopy Colors: White, Yellow, Red, Blue, Black, Orange, Green
Dimensions: 118" w x 125" h up to 138" h x 118" d
Product Parts
1 - Frame
2 - Canopy
11
2
ShowStopper Deluxe Event Tent 240620
Set-Up
Step 1
Remove the tent from the bag and placing it at your
desired location.
In tandem with another person, separate the legs of the
tent until they are extended a full arms length.
Step 2
Unfold your Canopy (2) and drape over the tent’s Frame (1).
Attach the Canopy (2) by connecting the loop strips on the
canopy corners with the hook strips on the frame’s four legs.
Position the canopy’s apex with the center pole of the Frame (1).
Step 3
Be sure the Canopy’s apex with the center pole of the
Frame (1). Stand diagonal to each other and separate
the frames legs. The frame will open a little at a time so
alternate ends until the Frame (1) no longer expands.
Step 4
Lift the expanding section of the frame upwards until the
four sliding connectors lock into place on the frame’s
legs.
Scan to view Product Instructional Videos or visit:
http://www.creativedisplaysite.com/showstoppertent.html

2/12
Warranty Information: All products are designed to provide the user with a cost-effective and durable product. Standard warranty is a ‘one year parts and labor’ warranty which
warrants product against defects in material and workmanship. It does not cover damage due to accidents, abuse, or normal wear and tear. Products found to be defective will
be replaced or repaired at factory’s discretion.
Set-Up Continued...
Care
Storage
Place all product parts into either your provided dust cover (Included), or
in the Hard or Soft Case (Not Included), and store in a cool dry location.
To clean, wipe with damp cloth.
Step 5
Once set, release and extend the telescoping legs. Raise
the tent to your desired height and lock the legs into
place
Step 6
Lift the apex of the canopy up into place by turning the
crank located on the center of the expanding frame.
Turn counterclockwise until the canopy is taut.
Secure with Stakes - Sold Separately
Simply drive the stakes through the holes in the feet and
into the ground to secure.
Secure with Ballast - Sold Separately
Simply strap the Ballast to the legs and fill with water or
sand.
Dust cover is for storage
only & is not a carry case