NRS Relief LEGEND 33 User manual

LEGEND 33 - ICRC/IFRC Standard
Technical drawing
Easy set up: 45 minutes
Front view
Side view
General view
A17x Tent poles
B6x Pipes
C12x Frame joints
D8x Standing poles
E4x Canopy supporting poles
F3x Shade net frames
40x Twisted rod pegs
Packing list
30x Steel pins
12x Tent pegs
1x Hammer
1x Flysheet
1x Inner
1x Ground sheet
1x Shade net

LEGEND 33 - ICRC/IFRC Standard
1
3 54 6
2
12x frame joints17x tent poles
2.1 2.2
A C
12x frame
joints
17x tent
poles
8x standing
poles
6x pipes
C
A
D
B
Slot the “A” poles into all the joints. Note: the longer parts of the joint should face to the side.
Layout all the poles and joints.
Spread the outer tent over the ridge pole. Assemble three identical shade net frames
using “F” poles.
Secure the outer tent by inserting the apex joint
pins through the eyelets.
Slot one shade net frame onto the apex joint
pins along the ridge pole.
F

LEGEND 33 - ICRC/IFRC Standard
Spread out the outer tent and secure by inserting side joint pins
through the eyelets. Ensure that the ends of the “A” poles are exposed
Secure the shade net to each end of the shade net
frames using the buckles.
Slot a shade net frame onto the joint pins along the each side.
Connect “B” poles to the end of each “A” pole and secure
with Velcro aps.
Spread the shade net over the top of the tent
Lift the tent frame and insert the standing poles into the upper
joints. Do the same for both sides of the tent.
7
10
8
11
9
12
11.2
11.1
B
F
D

LEGEND 33 - ICRC/IFRC Standard
Fix the outer tent to all tent poles using the Velcro loops.
Pull out all shade net ropes and tie onto the appropriate tent pegs.
Inside the tent, secure all lower black loops with a steel pin, until
20cm remains exposed.
Pull out the outer tent skirt. Secure with twisted rod pegs. Tie the
lower guy ropes to them. Note: gable end aps should rst be zipped.
Pull out all guy ropes, secure with tent pegs, and tighten with sliders.
13
16
14
17
15
14.1
14.2
20 cm