Shure Microflex MX405 User manual

MX405 and MX410 Miniature Gooseneck Microphones
www.shure.com
MX410 and MX405
Miniature Goosenecks
MX400SMP
Surface Mount Preamp
MX400DP
Wired Desktop Base (also available as MX890
Wireless Desktop Base)
Specifications (subject to change)
Type Condenser (electret bias)
Frequency Response 50–17000 Hz
Polar Pattern (at 1 kHz) MX405/C, MX410/C: Cardioid
MX405/S, MX410/S: Supercardioid
Output Impedance EIA Rated at 150 Ω (170 Ω actual)
Output Configuration Active Balanced
Sensitivity (at 1 kHz , open circuit voltage) Cardioid: –35 dBV/Pa (18 mV)
Supercardioid: –34 dBV/Pa (21 mV)
1 Pascal=94 dB SPL
Maximum SPL (1 kHz at 1% THD, 1 kW load) Cardioid: 121 dB
Supercardioid: 120 dB
Equivalent Output Noise (A-weighted) Cardioid: 28 dB SPL
Supercardioid: 27 dB SPL
Signal-to-Noise Ratio
(referenced at 94 dB SPL at 1 kHz)
Cardioid: 66 dB
Supercardioid: 68 dB
Dynamic Range (1 kΩ load at 1 kHz) 93 dB
Common Mode Rejection (10 Hz to 100 kHz) 45 dB minimum
Preamplifier Output Clipping Level (1% THD) -8 dBV (0.4 V)
Polarity 3-Pin XLR: Positive sound pressure on diaphragm produces positive voltage on pin 2
relative to pin 3 of output XLR connector.
5-Pin XLR: Positive sound pressure on diaphragm produces positive voltage on pin 4
relative to pin 2 of output XLR connector.
Weight MX405: 0.054 kg (0.119 lbs)
MX410: 0.068 kg (0.150 lbs)
MX400DP: 0.516 kg (1.138 lbs)
MX400SMP (w/ Kit): 0.125 kg (0.275 lbs)
Logic Connections LED IN: Active low (≤1.0V), TTL compatible. Absolute maximum voltage: -0.7V to 50V.
LOGIC OUT: Active low (≤1.0V), sinks up to 20mA, TTL compatible. Absolute maximum
voltage: -0.7V to 50V (up to 50V through 3kΩ).
Mute Switch Attenuation -50 dB minimum
Cable MX400DP: 6.1 m (20 ft) attached cable with shielded audio pair terminated at a 3-pin
male XLR and three unterminated conductors for logic control
Environmental Conditions Operating Temperature: -18–57 °C (0–135 °F)
Storage Temperature: -29–74 °C (-20–165 °F)
Relative Humidity: 0–95%
Power Requirements 48–52 Vdc phantom, 8.0 mA
Available Models
The polar pattern of the cartridge is indicated by the model number suffix: C = Cardioid, S = Supercardioid, N = No Cartridge
MX405/C, MX405/S 5 inch (127 mm) Gooseneck, bi-color status indicator ring, includes surface mount preamp
MX405R/N 5 inch (127 mm) Gooseneck, light ring, includes surface mount preamp
MX410/C, MX410/S 10 inch (254 mm) Gooseneck, bi-color status indicator ring, includes surface mount preamp
MX410R/N 10 inch (254 mm) Gooseneck, no cartridge, light ring, includes surface mount preamp
MX405LP/C, MX405LP/S 5 inch (127 mm) Gooseneck, bi-color status indicator ring, less preamp
MX405RLP/N 5 inch (127 mm) Gooseneck, no cartridge, light ring, less preamp
MX410LP/C, MX410LP/S 10 inch (254 mm) Gooseneck, cardioid, bi-color status indicator ring, less preamp
MX410RLP/N 10 inch (254 mm) Gooseneck, no cartridge, light ring, less preamp
Overview
Flexible in more ways than one, Microflex Miniature Gooseneck microphones deliver unsurpassed style and performance for conference rooms and similar
applications. Offering desktop or mounted bases, wired or wireless options, and even interchangeable cartridges, it’s easy to get the perfect fit for your
conferencing installation. Fully compatible with SLX® wireless systems, including the SLX4L wireless receiver with logic output for applications requiring
logic functionality.
*for detailed dimensions please
reference MX405/410 user
guide

MX405 and MX410 Miniature Gooseneck Microphones
Architectural Specifications
MX405/C - The microphone shall be an electret condenser 5” gooseneck microphone (12,7 cm) with cardioid polar pattern, black finish, and
logic controlled bi-colored status indicator. The microphone shall be mounted in the included MX400SMP preamp. The microphone shall be
resistant to RF interference from portable mobile and handheld devices. The frequency response shall be 50 Hz to 17 kHz and the sensitivity
shall be 18 mV/Pa.
MX405/S - The microphone shall be an electret condenser 5” gooseneck microphone (12,7 cm) with supercardioid polar pattern, black finish,
and logic controlled bi-colored status indicator. The microphone shall be mounted in the included MX400SMP preamp. The microphone
shall be resistant to RF interference from portable mobile and handheld devices. The frequency response shall be 50 Hz to 17 kHz and the
sensitivity shall be 21 mV/Pa.
MX410R/N - The microphone shall be an electret condenser 10” gooseneck microphone (25,4 cm) with no included cartridge, black finish,
and logic controlled, upper red light ring status indicator. The microphone shall be mounted in the included MX400SMP preamp. The
microphone shall be resistant to RF interference from portable mobile and handheld devices.
MX410/C - The microphone shall be an electret condenser 10” gooseneck microphone (25,4cm) with cardioid polar pattern, black finish, and
logic controlled bi-colored status indicator. The microphone shall be mounted in the included MX400SMP preamp. The microphone shall be
resistant to RF interference from portable mobile and handheld devices. The frequency response shall be 50 Hz to 17 kHz and the sensitivity
shall be 18 mV/Pa.
MX410/S - The microphone shall be an electret condenser 10” gooseneck microphone (25,4cm) with supercardioid polar pattern, black fin-
ish, and logic controlled bi-colored status indicator. The microphone shall be mounted in the included MX400SMP preamp. The microphone
shall be resistant to RF interference from portable mobile and handheld devices. The frequency response shall be 50 Hz to 17 kHz and the
sensitivity shall be 21mV/Pa.
MX410R/N - The microphone shall be an electret condenser 10” gooseneck microphone (25,4 cm) with no included cartridge, black finish,
and logic controlled, upper red light ring status indicator. The microphone shall be mounted in the included MX400SMP preamp. The
microphone shall be resistant to RF interference from portable mobile and handheld devices.
MX405LP/C - The microphone shall be an electret condenser 5” gooseneck microphone (12,7 cm) with cardioid polar pattern, black finish,
and logic controlled bi-colored status indicator. The microphone shall be compatible with the MX400SMP or MX890. The microphone shall
be resistant to RF interference from portable mobile and handheld devices. The frequency response shall be 50 Hz to 17 kHz and the
sensitivity shall be 18 mV/Pa.
MX405LP/S - The microphone shall be an electret condenser 5” gooseneck microphone (12,7 cm) with supercardioid polar pattern, black
finish, and logic controlled bi-colored status indicator. The microphone shall be compatible with the MX400SMP or MX890. The microphone
shall be resistant to RF interference from portable mobile and handheld devices. The frequency response shall be 50 Hz to 17 kHz and the
sensitivity shall be 21 mV/Pa.
MX410RLP/N - The microphone shall be an electret condenser 10” gooseneck microphone (25,4 cm) with no included cartridge, black
finish, and logic controlled, upper red light ring status indicator. The microphone shall be compatible with the MX400SMP or MX890. The
microphone shall be resistant to RF interference from portable mobile and handheld devices.
MX410LP/C - The microphone shall be an electret condenser 10” gooseneck microphone (25,4cm) with cardioid polar pattern, black finish,
and logic controlled bi-colored status indicator. The microphone shall be compatible with the MX400SMP or MX890. The microphone
shall be resistant to RF interference from portable mobile and handheld devices. The frequency response shall be 50 Hz to 17 kHz and the
sensitivity shall be 18 mV/Pa.
MX410LP/S - The microphone shall be an electret condenser 10” gooseneck microphone (25,4cm) with supercardioid polar pattern, black
finish, and logic controlled bi-colored status indicator. The microphone shall be compatible with the MX400SMP or MX890. The microphone
shall be resistant to RF interference from portable mobile and handheld devices. The frequency response shall be 50 Hz to 17 kHz and the
sensitivity shall be 21 mV/Pa.
MX410RLP/N - The microphone shall be an electret condenser 10” gooseneck microphone (25,4 cm) with no included cartridge, black
finish, and logic controlled, upper red light ring status indicator. The microphone shall be compatible with the MX400SMP or MX890. The
microphone shall be resistant to RF interference from portable mobile and handheld devices.
Optional Accessories and Replacement Parts
MX400SMP Surface Mount Preamp R185B Black Cardioid Cartridge for All
Microflex Models
A412MWS Metal Locking Windscreen A99WS Big Foam Windscreen
MX400DP Wired Desktop Base. Includes
10 ft. (6.1 M) attached cable
R184B Black Supercardioid Cartridge for
All Microflex Models
95A2487 Tapered Windscreen
MX890 Wireless Desktop Base. Compat-
ible with SLX wireless systems
R183B Black Omnidirectional Cartridge for
All Microflex Models
RK412WS Microflex Windscreen (4pk)
Furnished Accessories
Models with included Preamp All Models
MX400SMP Surface Mount Preamp RK513WS Snap-Fit Foam Windscreen
65A2166 Rubber Isolation Rings
65A2190 Wing Nut
95A1118 5 Pin XLR-F
65A2166 Cap
20 2000010001000050 100
9876543298765432
+10
0
ñ10
Hz
dB
-20
+20
Cardioid
20 2000010001000050 100
9876543298765432
+10
0
ñ10
Hz
dB
-20
+20
Supercardioid
www.shure.com
United States:
Shure Incorporated
5800 West Touhy Avenue
Niles, IL 60714-4608 USA
Phone: [phone]
Fax: [phone]
Email: [email protected]
Europe, Middle East, Africa:
Shure Europe GmbH
Wannenäckerstr. 28,
74078 Heilbronn, Germany
Phone: [phone]
Fax: [phone]
Email: [email protected]
Asia, Pacific:
Shure Asia Limited
3/F, Citicorp Centre
18 Whitfield Road
Causeway Bay, Hong Kong
Phone: [phone]
Fax: [phone]
Email: [email protected]
Canada, Latin America, Caribbean:
Shure Incorporated
5800 West Touhy Avenue
Niles, IL 60714-4608 USA
Phone: [phone]
Fax: [phone]
Email: [email protected]
©2007 Shure Incorporated